I have replace the crank shaft position sensor on my car eight times. Now my car will turn over but won't start. Any suggestions on what the problem might be
HI. I read your problem.
Let me ask you,
The sensor that you are installed are from the dealer or aftermarket?
Because the crank sensor on a 02 to 06. altimas where defectives. or damaged to fast.
Is why NIssan company Made a complety diferent new sensor.
Trying to resolve this problem.
If you haven't get from the dealer, I recomment get one from them. When you see the connector on inverter position don't worry it will fit.
But if you install from the dealer. I recoment check the engine for high vibration.
Check the crankshaft for end play.
And check the wires from the sensor for short, or burned shield.
OK> I hope this work for you..
I have changed few of them..
SOURCE: CRANK SHAFT POSITION SENSOR 20002 NISSAN ALTIMA
1st, Nissan had a recall on Crank position sensors for 2002-2006 Altima's. Check with you dealer before you go doing any repairs. You may discover you can get your car repaired at no charge.
NHTSA Campaign ID number :O7V527000
Symptom: Erratic behavior. Stalling and no starts and very difficult to diagnose due to the time frame in which the component actually malfunctions. The warranty should not be limited to the original owner.
I would also need more specifics as to which engine you have so I might assist you in where the location of the sensor is. The Altima had a 4 and a 6 cyl engine offered that year.
426 views
Usually answered in minutes!
Engine cranks then starts clicking and won't start. 2003 Nissan Altima
×