It's when the security light starts flashing that the infamous "chip" in the key becomes a nightmare to many. Gradually the car begins not cranking anymore or if it cranks it would start and die in a second. Randomly it will do this more and more often until it won't start anymore. VATS, PASSkey and Passlock immobilizer systems are killing cars all over North America, they have a short lifespan and are certainly more effective against owners than thieves. Here is how you save your car
1st trick, (if not starting) turn the key forward 2 clicks till right before it would normally start, leave like that for 10 minutes. ( no less ) After 10 minutes, turn key back then forward and your car might start. I did this in my regal for more than a year. If its shuting down while running, im sorry i have no quick fix...
Cheap fix: Bypass the chip in your key. Temporary, but effective. Until the TDM (theft deterrent module) in the dash poops out, then you're kinda screwed. I was told that these types of key security systems have a 7-10 year life span. Sucks for us. This link explains the "Key Issue" pretty well.
----- http://vats.likeabigdog.com/
Never worry again fix: Bypass the whole VATS/Passlock/passkey I or passkey II system entirely. Literally take it out, and throw it away. I just did this in my Regal. Took about an hour. Took longer to find the thing than it did to fix the problem. For a list of cars effected by this problem. See the NEWROCKIES link on the right side of their page......... They sell a unit for 200 bucks to totally bypass this system FOREVER. life time-money back and all that. Finally did this in my car. Well worth the 200 if you've looked into getting this replaced... Anywhere from 600-1000 bucks.
----- http://newrockies.ca?ap_id=judd0081
----- With this fix, you can take that whole Vats, passlock, passkey **** system out of your car all together. Good info on both sites
It works for:
Any GM or Isuzu Vehicle with VATS or PASSKey or PASSLock security systems.
If your car has the chip in the key or in the lock cylinder, then you can save it with this Full Bypass.
Trucks
.
GMC/Chevy
1998-2006 S10/T10/Sonoma
/Blazer/Jimmy
1998-2007 Suburban/Avalanche
/Tahoe/Yukon
1998-2006 Sierra/Silverado
2002-2008 Trailblazer
2003-2006 SSR
1998-2006 C1500/C2500/C3500
1998-2006 K1500/K2500/K3500
2003-2007 Hummer H2
.
Isuzu
1998-2000 Hombre
2005-2006 I280/I350
2007-2008 I290/I370
.
Cars/Vans
.
Isuzu
2003-2007 Ascender
.
Pontiac
1994-2003 Grand Prix
1998-1999 Montana
2006 Torrent
1996-2005 Grand AM
1994-1998 Trans Sports
1988-1999 Bonneville
1988-2002 Firebird
1995-2005 Sunfire
1996-2002 Trans Am
.
Buick
2004-2007 Rainier
1994-2005 Century
1993-2004 Regal
1982-1999 LeSabre
1991-1996 Park Avenue / Ultra
1994-1996 Roadmaster
1991-1996 Roadmaster Estate Wagon
1982-1999 Riviera
1988-1991 Reatta
1996-1998 Skylark
1982-1990 Electra (all models)
.
Oldsmobile
1996-1998 Achieva
1999-2004 Alero
1994-2004 Aurora
1998-2004 Bravada
1991-1993 Delta 88
1994-1999 Eighty-Eight
1991-1996 Nighty-Eight
1998-2002 Intrigue
1990-1992 Toronado
1994-1997 Cutlass Supreme
1997-1999 Cutlass
1997-1999 LSS/Regency
1997-1999 Silhouette
1991-1996 Custom Cruiser
.
Chevrolet/GMC
1998-2005 Astro/Safari
1998-2008 Envoy
2005-2006 Equinox
1998-2007 Savana/Express
1995-2005 Monte Carlo
1997-1999 Venture
1995-2001 Lumina
1988-2002 Camaro
1995-2005 Cavalier
1982-2004 Corvette
1994-1996 Caprice/Caprice Wagon
1995-1996 Impala SS
2000-2005 Impala
1997-2005 Malibu Classic
1997-2003 Malibu
.
Cadillac
1986-1993 Allante
1982-1996 Fleetwood
1985-1996 Fleetwood Brougham
1992-2004 Seville
1992-2004 SLS/STS
1985-1999 Deville
1994-1999 Deville Concours
1997-1999 Deville D'Elegance
1988-2002 ElDorado
1994-2002 ElDorado Touring
1999-2007 Escalade
.
Saturn
2000 LS/LS1/LS2/LW1/LW2
2001-2002 L100/LW100
2001-2003 L200/LW200
2001-2005 L300/LW300
2004-2005 L-Series
2002-2008 VUE
1996-2002 SL/SL1/SL2
1996-2002 SC1/SC2
1996-2002 SW1/SW2
What type of vehcile? most likely in some models the passlock sensor has failed.
Check the ignition system on ur corvette. i think the fault lies there.
You'll have to change out the steering column or actually the ignition key cylinder but keep the door lock key...after you change the key cylinder lock the doors with the key then unlock the doors with the key and it should start and run fine
SOURCE: replaced multiswitch in 2000 chevy s10 blazer and now the car won
at the base of the steering column there a orange and white wires these two wires come from the ing switch, you will see the connector that they go to disconnect that take a ohm meter, take the leads one lead to one wire the other lead to the other there should be res, if there is not, try a different setting . take your ing key on the the key you will see a chip take two leads from your meter and either side of the chip place the leads you will see a res reading, you should see the same at the orange and white wires . if you do not replace the ing switch the switch will come with these wires. replacing the switch takes a couple specail tools good luck and let me know how it gose
SOURCE: security light flashes
from what i have read, it is design to cut the gas supply so no one can still your car. Mine car wouldn't crank at all with the light blinking. turn the key to the on position and wait 10 minutes. turn it off and try to crank it. it has worked every time on mine. I have also read to cut the LITTLE yellow wire that runs from ignition,but i don't feel comfortable cutting wires even though you can always reattch the wire.
SOURCE: 1993 pontiac bonneville won't start when security light is on
Here is a detailed write-up on how to bypass the entire VATS security system yourself.
http://newrockies.ca/vatsbypass
This is what saved my car and my money (that I didn't have!).
SOURCE: my security light comes on and i can't start my car
your car security system can not be disable but it can be bypass
but firts on these models it is the pass key the problem
on your key to strt the car you have a little round black thing with a little metal contact this is a resistance that is in your key when you put it in the hole to start your car it mesure the ressistance
and the you can start your car
the usual problem with this system is that in the ignition key lock cylinder there are two wire
and usualy one of the two wire just cut so i would remouve the stearing wheel and get that wire fix
hope that will help you !!!
the way to bypass the system is easy but you need to realy know what you will be doing
first you mesure the ressistance in the key in (ohm) and second get a ressistance the same value from any places that sells electronics
after you will find in your car the passkey decoder module (behind right side of i/p)
the two wires that come out of the box (B7 ppl/wht and B8 wht/blk)
cut these two wires and weld the ressistance in bettwen
this way you won t have to take your stearing appart
and your system will be bypass for ever
great day to you
Denis
SOURCE: security light blinks car won't start
The process for the passlock relearn is correct. If by chance the relearn does not work, you may have a fail component in the system. Go to this link for options to fix this yourself.
http://vatspasslockpasskeysecurityhelp.yolasite.com/
5,844 views
Usually answered in minutes!
×