INSTALL STARTER CODE FOR INSTALLING THE STARTER FOR A 1998 MERCEDES 320E HOW DO I GET IT AS I AM INSTALLING IT MYSELF

Drain engine oil and tranny oil from engine, replace with correct amount of engine oil. Check on getting a Chilton or Haynes repair guide for your vehicle. This will help you better understand your vehicle.

If you need further help, reach me via phone at https://www.6ya.com/expert/frankie_091f536560a54e12

could be touching something

go on google images should be a diagram on there

try asking here

www.ukbookshelf.co.uk

Most likely pistons leaked and system is low on hydraulic fluid.

The only place you can get that is from the dealer.

1999 Honda Civic DX 1.6L MFI SOHC 4cyl
Starter Removal & Installation



Fig. Starter wire connections



Fig. A ratchet and long extension may be needed to remove the starter

The factory sound system has a coded theft protection system. It is recommended that you know your reset code before you begin.

1. Disconnect the negative battery cable.
2. Remove all wiring from harness.
3. Remove the lower radiator hose from the bracket on the starter motor.
4. Remove the starter cable from terminal B located on the back of the solenoid.
5. Remove the black/white wire from the S (solenoid) terminal.
6. Remove the two bolts that mount the starter to the transaxle assembly.
7. Remove the starter.

To install:

1. Install in the reverse order of removal.

When installing the heavy gauge starter cable, make sure the crimped side of the terminal end is facing out.

1. Enter the anti-theft code and radio presets.

I hope help you with this (rated this help). Good luck.

hold both the lock and unlock buttons at the same time.after 5 seconds it should honk.that means it will honk when locked..in the settings on the dash there is the ability to change the headlight delay,etc and it may be in there too to flash the lights,honk etc.

Hi Rafal Joe here to help, There are two torx head screws on the back of the steering wheel. It takes a special Mercedes Benz tool to do so. After removal there are airbag connectors that need to be removed. Be careful not to break them, They are plastic.

no it should not be a problem if the car has been well maintained and in good shape I would not be afraid to buy it