Question about 1995 Nissan Maxima

2 Answers

1995 nissan maxima On the positive pole side of the battery there is an addition connector attached to the cable, a small red colored plastic clip-on that will seperate into two parts. Inside two contacts I can see, and they are very corroaded and hard to clean. What is the name of this connector? Thanks Doug

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that has over 10 points.

  • Contributor
  • 18 Answers

Fuseable link

Posted on Dec 26, 2017

Ad

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Nissan Master
  • 2,558 Answers

Here is the name of the cable you ask for:
Battery Cables with Leads .
-You can replace with the new one or just clean.
-Best way and safe to clean battery's corrosion.
-Use baking soda.
-Wet all area that you need to clean then shake baking soda onto it. Make sure all surface get it. let it soap for 5-10 minutes then use nylon brush to brush back and forward for couple minute then rinse with water. After dry use battery corrosion protection to spray on to it. So it will last for a while depend on how good it was cleaned.

Good luck and enjoy

Mai

Posted on Dec 26, 2017

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

chris07551

  • 726 Answers

SOURCE: 1997 nissan maxima-no communication from the data link connector

theo other way is do do the codes by the computer should have to lights on the side and flashes red and green if there not there the data link my be screwed up a little try blowing in it make sure the connectors are in good shape check all fuses and wiring to the link

Posted on Sep 14, 2008

Anonymous

  • 82 Answers

SOURCE: 1996 Nissan Maxima oxygen sensor

hye there ,,there are 3   o2 sensors on your car,,one for each bank,,,and the 3rd sensor is located after the cat this one usually goes first,,,,just make sure you no if your cars an import or not as they can be different,,,then you should be safe when ordering ,,hope that helps,,,

Posted on Apr 24, 2009

Anonymous

  • 20 Answers

SOURCE: How to remove the radio - 1996 Nissan Maxima QX cd/c assette play

If the unit has 4 small holes on the face, get a wire hanger and insert into all 4 holes at once, releasing the retaining clips.
If unit does not have 4 holes on face, remove dash panel around stereo. This can be done by simply pulling the panel off, as it is only held on with "pop in" clips. The unit will be hard fastened to the car with screws and brackets that are easily accessable and will be visible when the dash panel is removed.

Posted on Jun 28, 2009

Chris Wiggins

  • 5 Answers

SOURCE: window on passenger side of

If it makes a sound when you try to roll it up then it isn't the motor. If thats the case the window probably fell off the window regulator track. To fix it you have to take off the door panel and put the window back in the track.
If you don't hear a sound when you try to roll it up it is most likely the window regulator motor. In that case you can buy a replacement online at a place like rockauto.com or go to a junk yard to get it cheaper.
More unlikely problems could be the electrical wiring is messed up somewhere in the car or the master window switch is out.

Posted on Feb 28, 2011

archaeology

Archaeology

  • 662 Answers

SOURCE: what are the fuses attached

These are fusible links.
(1) 50 Amp - wire color W/B - to BCM (Body Control Module) lead 55
(2) to lead 1 ABS/TCS Control Unit
(3) to lead 15 ABS/TCS Control Unit

Posted on Sep 05, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Trying to charge battery for first time. It says connect two red connectors. Do you charge it first then connect the connector afterwards?


1. I assume this is a car battery so the first thing you do is to disconnect the vehicle cables from the battery terminals. The negative first and then the positive. The positive terminal is marked with a plus sign ...+ ... When refitting the cables to the
battery after it is charged you fit the positive cable to the positive battery terminal(+) first and fit the negative(-) last.

2. Now that the battery is unconnected from the vehicle you can fit the charging cables to the battery terminals. The charger you have should have 2 cables leading from it , a positive with a red plastic insulation on the clip and a negative cable probably with black insulation on the clip.The instructions with the charger will tell you in which order the cables are to be attached to the battery and the order you remove them. Each of the 2 cables has to be clipped onto the correct battery terminal. The positive cable(+) from the charger goes to the positive battery terminal (+)and the negative cable(-) from the charger goes to the negative battery terminal(-).

3. Once the cables from the charger are properly connected to the battery, you can plug in the charger and turn on the power.

4. Batteries generate explosive gasses when being charged and it only takes one small spark to ignite them. Don't reconnect the battery after charging for a half hour or so and make sure the area where you are charging is well ventilated.

Dec 18, 2015 | Cars & Trucks

1 Answer

Car won't start except when charger hooked to red cable


I would expect to find too much corrosion on the positive cable end.

Jul 11, 2013 | Cars & Trucks

1 Answer

What are the fuses attached to the positive battery cable on a 2006 Nissan Maxima?


These are fusible links.
(1) 50 Amp - wire color W/B - to BCM (Body Control Module) lead 55
(2) to lead 1 ABS/TCS Control Unit
(3) to lead 15 ABS/TCS Control Unit

Sep 05, 2011 | 2006 Nissan Maxima

1 Answer

How can i change out the ignition switch on 94 nissan quest?


  1. Position the vehicle with the front wheels in a straight ahead position.
  2. Disconnect the negative battery cable.
  3. Disconnect the positive battery cable.
  4. Wait at least ten minutes for the air bag back-up power supply to drain before continuing.
  5. Remove the driver's side lower instrument panel cover. On 1993-94 vehicles, remove the cover screw, then pull out on the cover to release the clips. On 1995 vehicles, remove the five cover screws, then pull out on the cover to release the clips.
  6. Remove the four driver's side lower instrument panel reinforcement bolts and remove the lower reinforcement.
  7. Remove the ignition switch electrical connector bolt and disconnect the connector.
  8. Remove the two ignition switch screws.
  9. Remove the ignition switch from the steering column.
    93248gc4.gif

    Removing the driver's side lower instrument panel reinforcement bolts
    93248gc4.gif

    Removing the ignition switch electrical connector bolt
    93248gc6.gif

    Removing the ignition switch screws

To install:

  1. The installation is the reverse of removal. Tighten the lower instrument panel reinforcement bolts to 29-39 inch lbs. (3.2-4.4 Nm

Jun 13, 2011 | 1994 Nissan Quest

3 Answers

How to remove the battrey on a toyota rav 4 2006?



It is the removable Cowl (plastic piece where the windshield wipers sit on). The section that comes off is on the drivers side. Open the hood and you will see a few large flat screw clips that can be opened with a large flat screwdriver
After taking the plastic cowl off, you have to take off the
little metal bracket that holds the battery down.
don't forget to take off the Positive and Negative connectors first.
if this is helpful, please give it a thumbs up to help others too.

May 20, 2011 | 2006 Toyota RAV4

1 Answer

I have a 1997 Nissan Maxima GLE- My problem is it will not start. It'll turn over but will not start. I've replaced the starter, bad battery, negative cable, oxygen sensor and crank sensor. I do know that...


I had the same problem with my 1995 maxima finally replaced the camshaft position sensor its on the passenger side topend small black piece held on by one bolt and wire harness clip attached to it about 50/60 bucks at any autoparts store I got ine on ebay for 25bucks. Started right up with no problem hope this helps. This is the part below

Dec 04, 2010 | 1997 Nissan Maxima

1 Answer

Hi i took my battery out and now im attempting to replace the battery but i am not sure if the positive end is on the left or right side. which side is the positive cable?


Are you standing in the store trying to figure this out? I do it all the time, so now I write it down before I go shopping. The battery cable in your car with the most stuff attached to it is the positive. Usually covered with a plastic cap so nothing will short against it. The positive side of the battery is marked with a red cap or a big plus sign, +,, Remember, red is hot,

Feb 16, 2010 | 1996 Nissan Maxima

2 Answers

Where is the positive pole of battery


It should have a + sign on it. Or, if it's in the car already, it will have a + sign, and the red cable will be hooked to it. The negative runs to the engine block, and the positive to the starter, or relay. Both are marked with a + or - sign molded into the battery body.

Jan 26, 2010 | 1996 Nissan Altima

1 Answer

Car will not started radio and door locks dosent work


If the battery is good dissconect the ground and clean it until its silver in color on the battery and copper color on the terminal connector. If that doesn't do any good remover that ground wire again then check the battery positive cable running to the starter. It may be loose. If so remove it and clean it very good. Re-enstall with a star washer to lock in place for keeps & check

May 22, 2009 | 1995 Nissan Maxima

Not finding what you are looking for?
1995 Nissan Maxima Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...