How do i change the oil pressure sensor on a 2000 chrysler town and country

1st locate your sensor, most of the time, they are up on the engine itself, you will need a oil sending socket and ratchet to do the job, once you locate your sensor, disconnect the wiring connector to it, then remove the sensor, and before you install the new one, take some white teflon tape, that you can buy at a auto part store, and wrap some tape around the threads of the new sensor, [ normally 2-3 rounds is enough tape. ] install the new sensor straight in to the opening, make sure you don't cross thread it, after you get the sensor started, then tighten it up as much as you can with your hand, then finish tightning with ratchet and socket, [ do not over tighten ] then hook wire connection back up, and you are ready to go, start vehichle up and check for any leaks, of the sensor, they shouldn't be any, if you followed these instructions, hope that this has been helpful to you.