Hi, my name is John I will do my best to assist you.
To Remove
To Install:
NOTE: The target magnet has 2 locating dowels which fit into the machined locating holes in the end of the camshaft.
The camshaft position sensor is mounted to the rear of the cylinder head - SOHC engine shown
Location of the camshaft position sensor - DOHC engine shown
Unfasten the retaining bolt, then remove the target magnet from the rear of the caHow do I replace the CAM sensor on a 1996 dodge - tecnovative_141.gif, DOHC similar
It will be on the left hand side at the end of the valve cover on the head.
SOURCE: Cam Shaft Sensor Problems
Had the same problem before on my 04 Neon SXT...camshaft sensor is on left side of engine block, take out the battery and to the left of it (face car) is the camshaft position sensor. To change it you'll have to move a few hoses but its plan to see there on the left side of the engine...pretty easy remove and replace. Fixed my problem of car not going above 2k RPM when i replaced the sensor.
SOURCE: 2005 dodge noen cam sensor
I own a 2002 neon sxt and recently had to replace the cam sensor it should be in the same place.
look on the right side of the motor you should see it. it'll have a small wire harness that clips in the top and its fastend with 4 bolts. Oh and take the battery out before you do it it makes it a lot easier.
Hope this helps.
SOURCE: 1997 dodge neon. replaced coolant temperature
1997 Plymouth Neon, have replaced radiator, radiation cap, thermostate and hoses, still run hot. Fans do not seem to come on, where is the temperature sensor on this vehicle?
2,399 views
Usually answered in minutes!
×