SOURCE: Seating rear brake piston on 96 Buick Regal
check local auto parts store for special tool, does not cost much and easier to use than pliers
SOURCE: hood latch & cable broke in a 96 buick regal
You should be able to pick up a used one at a junkyard for less than $20
SOURCE: i have a 1999 buick regal ls dying.
I found the problem. It was the crank position sensor. There was also a cracked vacuum hose connecting to the diaphragm on the fuel rail. Replaced both and my 92 Buick no longer dies. For the guy who's Buick was dying when using the turn signals - replace the crank position sensor. One of my symptoms of my Buick dying was when I used my turn signals. Use of turn signals places a varying load on the electrical system which messes up the crank posistion sensor if it is going bad.
Bob
SOURCE: wheel studs
The studs are pressed into place. You can remove them and replace them using a vise, and a couple sockets (one larger, and one smaller). You do need to remove the "wheel hub" from the vehicle to perform the repair.
SOURCE: how do u remove the wheel hub off a 96 buick regal
if it has a lock on it thin you need a key but a Flathead should just fit in there to pop it off
267 views
Usually answered in minutes!
×