SOURCE: 1992 chevy s10 no brake lights or turn signals
Check the front and rear (although probably the rear) turn signal bulb socket for corrosion and/or water intrusion. If you find corrosion attempt to clean (but you will probably have to replace the socket and bulb). For water intrusion you will probably have to replace the break lamp assembly.
SOURCE: 2000 chevy S10 Will not start in the morning ,
when was last tune up?seems to be classic case of bad spark plug wires and worn dist.cap and rotor.
SOURCE: I have a 1998 Chevy S10 pick up, have a starting
can you turn the engine by puting a wrench on the harmonic balencer? if not then the engine is locked up!!! if you can turn it this way then check your battery conections and body grounds!!
SOURCE: 2000 chevy express 1500 van having starting issues
Start with fuel system. Listen for fuel pump humm at fuel tank No humm check wiring to pump for power. Then check for spark at plugs and wires. Remove wire from coil and hold near engine and see arch when you crank. No arch. Replace ignition Modular inside distributor cap or cap or rotor
SOURCE: 2000 chevy s10 ex cab 2wd has leaky lines by
These are oil cooler lines and there are 2 sets of 2 and should be replaced, Fairly easy but messy. If one blows apart you run the risk of causing severe engine damage.
674 views
Usually answered in minutes!
×