P0171 P0174 - 2005 Ford Taurus

SOURCE: p0171 and p0174 codes

P0171 System too Lean (Bank 1)
P0174 System too Lean (Bank 2)

If a car has a check engine light on and has P0171 and P0174 codes stored, the most likely cause is a vacuum leak. These codes are set by the car’s computer when it sees too much oxygen in the exhaust. Excessive oxygen readings in the exhaust will set lean codes. This does not mean that the oxygen sensors are defective. It is a common mistake for people to replace oxygen sensors when lean codes are present. Just because the code is related to oxygen sensor readings, it doesn’t mean that the oxygen sensors are bad. If both of these codes are stored this means that both banks of the engine have excessive oxygen in the exhaust. If the oxygen sensors are replaced it’s most likely that the same codes will reappear. It is very uncommon for two oxygen sensors to fail at the same time.

Therefore the most likely cause of P0171 and P0174 codes is a vacuum leak. The source of a vacuum leak can be one of many things. The most common cause of a vacuum leak is a leaky hose. Vacuum hoses over time can become dry and brittle. The rubber deteriorates and can leak causing a vacuum loss. Many times a leaky vacuum hose can be found by listening for a hissing sound. A large vacuum leak can even make the car run rough at idle. In some cases it will not idle without feathering the gas pedal.

SOURCE: Codes P0171, and P0174 bLean on a 98 Navigator. Any ideas?

O171 MAF (Mass Airflow Sensor) Just try cleaning this part it usually solves that problem without having to buy new part.

0174 Both are mass air flow sensors. The other problem can be a vacuum leak Check PCV valave and all vacuum lines. Also make sure fuel filter and fuel pump are working correctly. You can clean the MAF with some brake cleaner make sure it is dry before you install it back

SOURCE: 1999 ford taurus emission reading p0171 and p0174

just tune up ur car periodicly, clean filter. clean ur sparkplug.

SOURCE: diagonostic trouble codes reported p0171

P0171 is system too lean bank 1, P0174 is too lean bank 2, and 302 is misfire bank 1. Look for vacuum leaks. If you don't find them, put a vacuum gage on it can check. The P0171 is almost always a vacuum leak. If not other possibilities are front O2 sensor is too old and should be replaced (if mileage is greater than 100k then replace). Try injector cleaner. Misfires are usually bad spark plugs, but could possibly be caused by insufficient fuel. I've never had a car of mine in bad enough shape to have that error.

SOURCE: codes p171 and p0174 on a chevy truck?

Subject: 97-05 Vehicles with 4.8 5.3 5.7 and 6.0 Gen III V8 Engines and Misfires on One Bank - kw CEL diagnostics driveability DTC P0171 P0172 P0174 P0175 P0300 P0301 P0302 P0303 P0304 P0305 P0306 P0307 P0308 #PIP3056 - (07/12/2004)

Models: (00-05 Cadillac Escalade - C6 and K6) and (02-05 Chevrolet Avalanche - C1, C2 K1 and K2) and (99-05 Chevrolet Silverado - C1, C2 K1 and K2) and (00-05 Chevrolet Suburban - C1, C2, K1 and K2) and (00-05 Chevrolet Tahoe - C1 and K1) and (99-05 GMC Sierra C1, C2 K1 and K2) and (00-05 GMC Yukon - C1, C2, K1 and K2) and (03-05 Chevrolet Express G1, G2, G3, H1, H2 ) and (03-05 GMC Savana G1, G2, G3, H1, H2 ) and (04-05 Buick Rainier S1, T1 ) and (03-05 Chevrolet Trail Blazer EXT S1, T1 ) and (03-05 GMC Envoy XL XUV S1, T1 ) and (03-05 Hummer H2) and (04-05 Cadillac CTS-V DB) and (98-02 Chevrolet Camaro FB) and (97-04 Chevrolet Corvette YB) and (98-02 Pontiac Firebird FB) and (04-05 Pontiac GTO VB)

The following diagnosis might be helpful if the vehicle exhibits the described symptoms.

Condition/Concern:
Check Engine Light with a P0300 due to 2 - 4 cylinders misfiring on the same bank of the engine. DTCs P0171, P0172, P0174 or P0175 may also set for the misfiring bank.

Recommendation/Instructions:
If the published misfire diagnostic does not isolate the cause, perform the following suggestions as necessary:

• Perform a fuel injector balance test for all 8 cylinders. If a fuel injector concern exists, it is possible to misfuel an entire bank of the engine, causing multiple cylinders on the same bank to misfire even though the root cause is a single fuel injector.
• Inspect O2 sensor connections on the misfiring bank for corrosion or water intrusion. If water intrusion is found on the right bank, it may be due to the AC Evaporator Condensation dripping onto the O2 sensor harness. If this condition is found, reposition and shield the harness to prevent a repeat concern and repair the connections.
• Check for excessive exhaust backpressure using the restricted exhaust diagnosis.
• Swap the Position 1 O2 sensors side to side to see if the misfires move to the other bank of the engine. If so, replace the O2 sensor.