Assuming you have the V6 3.2L engine (no diagram available for the L4 motor), the diagram is below. Thanks for using Fixya!
Greg
SOURCE: serpentine belt install 2001 isuzu rodeo 2wd 4cylinder auto
I believe that you need a 14MM or 15 MM wrench a long one would be the best since the spring is hard to move. There should be a nut on the tensioner pully #6 on the picture below. This is where you need to move the tensioner with one hand and pull the belt off with the other. It might be easier with 2 people. Remember the belt routing it will help when installing the new belt. Good luck.
SOURCE: i need a serpentine belt diagram for a 2000 isuzu
Here's two belt routing diagrams.
The first is for the 2.2L engine and the second is for the 3.2L.
Hope this helps.
Testimonial: "THANK YOU!! I was going crazy. Couldnt have done it without you help. "
4,353 views
Usually answered in minutes!
there ya go!
×