Honda Civic Coupe Logo

Related Topics:

Posted on Jan 09, 2018

CIVIC FOG LAMPS (8th Gen VTI sedan - AUS)

Hi,

Where can I find an instruction manual (with pictures) to fit OEM fog lamps on my civic? I bought a kit of MrSaveAuto. The kit comes with a switch. I cannot wire it directly into my Parker lights as I hear this will void my new car warranty.

Cheers

Anthony

5 Related Answers

Anonymous

  • 3 Answers
  • Posted on Jul 12, 2008

SOURCE: 03 Honda Civic LX keyless remotes . . .

THE DEALER SHOULD BE ABLE TO TELL YOU BY THE VIN NUMBER IF THE CAE CAME WITH A FACTORY KEYLESS ENTERY THAN YOU CAN BUY THE REMOTE PAD AND PROGRAM IT

Ad

Anonymous

  • 26 Answers
  • Posted on Jul 21, 2008

SOURCE: How to replace a wing mirror on 95 Civic VTi Hatchback

There is a black plastic cover on the other side of the mirror, take it off make sure you have the wires long enough to splice back to you will be able to see all the bolts that need to come off to replace the mirror. You will be able to figure out the rest it is very simple

Anonymous

  • 27 Answers
  • Posted on Nov 07, 2008

SOURCE: honda civic 1.8 vti 1998

look in the manual for warning lights and see if it sez atin about and if it dont get a dianostic check and it should tell

Anonymous

  • 1 Answer
  • Posted on Nov 23, 2008

SOURCE: i need radio wiring diagram

I just installed a radio and speakers in my 1992 Civic LX (132323 miles). Most radios are removed by disassembling some of the dashboard components. On mine I had to remove the lower center console (where the ashtray/lighter is located) to access the rear of my old radio. There is a metal support strap back there which stabilizes the radio and provides equipment grounding. This has to be removed from the radio before you can un-install the radio. Also there may be a metal mounting sleeve around the radio, if so you must use (2) thin metal strips (or thin screwdrivers)to disengage the (2) side clips from the sleeve. You should then be able to remove your old radio.
As for wiring , I had to discard the wire harness the came from the old stereo and hard wire the new unit. I used a 12v circuit tester to find my (+) positive (typically red) and (-) negative (typically black) leads. Speaker wires are in pairs. (example: blue/white white/blue or white/white-black)

Anonymous

  • 50 Answers
  • Posted on Mar 14, 2009

SOURCE: 97 CIVIC DX HATCH REVERSE LIGHTS NOT WORKING AUTO/MANUAL SWAP

it is very difficult to match wiring harness from auto tranny to manual tanny they are different connectors and reverse lights on auto tranny was connected to the nuetral safety switch about 6 to 8 different wires on manual tranny there is a switch located on the top of the tranny and backup lights are connected only with 1 wire you may need to get some help from auto electrition this should not cost alot of money to fix thanks

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

Fog lights not working on 2006 Nissan Maxima

The most likely cause is a 'short' in the wiring. Remove the light fitting and take a good look at the connections on the actual light fitting. Look for dirty or damaged parts. Check the wires and the connector blocks are clean, shiny and are not damaged. Then check the light fitting itself for damage. Check the seal where the light fitting fits against the bodywork. If moisture or water is getting past it can affect the lights.
0helpful
1answer

What is the best/easiest method of wiring aftermarket fog lamps so that they will work when the ignition is on?

Foglights are illegal in clear weather, so just leave them unconnected. People will appreciate the great look even when not on.
0helpful
1answer

How turn on my fog lights on 99 montana or its turn on by itself

Fog Lamps The fog lamps switch is located in the instrument panel switchbank. Push the fog lamp symbol on the switch to turn on the lamps. The indicator light will glow. Push the ribbed part of the switch to turn them off. The indicator light will go off. Your parking lamps or headlamps must be on for your fog lamps to go on.
http://www.pontiac.com/content/dam/pontiac/northamerica/usa/nscwebsite/en/Home/Owners/Owner_Resources/Manuals/en/us/1999/montana/1999-pontiac-montana-owners-manual.pdf.pdf

Page 2-63 of owners manual
0helpful
2answers

How do I turn on fog lights on a Cadillac escalade esv 09

If it is a turn knob for lights just pull out on knob
0helpful
1answer

Looking for fuse for fog lights on a 2008 dodge charger. we installed a fog light kit. the car is pre-wired for them. we replaced the head light switch with the one from the kit. fog lights arent...

Check your instructions with the fog lamps, I believe you will need to take your car to a dealer to have them activate the fog lamp driver in the Totally Integrated Power Module.
1helpful
2answers
0helpful
1answer

Fog Lights won't come on?

Check fuses,
Note you probably must have parklights 'on' before foglights will operate (Check user manual for fog lamp operation (interlock) requirements),
Check operation of fog light relay (if fitted),
Check fog lamps and bulbs are ok.
0helpful
1answer

Wiring harness for fog lights?

Just contact your local dealer and ask them for instructions for the OEM fog lamps. I have ordered Honda fog lamps, and you can usually find a pdf document on line with detailed instructions. The nice thing about Honda accessories, is the harnesses will only plug in one way. Hope this helps
Not finding what you are looking for?

64 views

Ask a Question

Usually answered in minutes!

Top Honda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...