Trying to find the fuse location for 02 rendevouz radio. There is no indication on fuse panel door under glove compartment left side panel.

look in glove compartment for owner manual, it has all fuses and relays location,fuse box should be under left driver side instrument panel and relays located under hood in the engine compartment.

When you are talking about "indicators" we could assuming that your are refer about signal lights. This work with "flashers" devices.

For 1996 Audi A4 2.8L SFI 6cyl the Flasher is located in front seating area, driver side, under dash, behind dash lower panel, mounted above driver side of steering column.

About generic fuses, open the driver side door. Remove panel on left side of dash. Fuse box is behind panel:

Fuse # / Description / Amps
1 / Heated washer jets / 5
2 / Turn signals flasher unit / 10
3 / Headlight washer, illumination of glove compartment, engine compartment, climate control, automatic transmission, instrument cluster / 5
4 / License plate light / 5
5 / Instrument cluster, seat heating, test connection for cruise control, bulb monitor for auto-check control, Automatic transmission display, switch lighting, mirror switches and actuators, airbag warning light, outside temperature indicator, Climate control / 10
6 / Central locking system / 5
7 / Anti-lock brake system / 10
8 / Vacant
9 / Mirror heating / 10
10 / Vacant
11 / Cruise control (automatic transmission) / 5
12 / On board diagnostic system / 10
13 / Brake lights / 10
14 / Interior lights, reading lights, anti-theft alarm system, vanity mirror / 10
15 / Instrument cluster, power windows, climate control, automatic transmission / 10
16 / Anti-lock brake system, Anti-Slip-Regulation / 5
17 / Heated door locks / 10
18 / High beam right / 10
19 / High beam left / 10
20 / Low beam right / 15
21 / Low beam left / 15
22 / Tail and side marker right / 5
23 / Tail and side marker left / 5
24 / Wiper and washer system / 25
25 / Blower for heating, climate control / 30
26 / Rear window defogger, mirror heating / 30
27 / Rear window wiper / 15
28 / Fuel pump / 15
29 / Engine timing / 20
30 / Sun roof / 20
31 / Tail lights, cruise control, automatic transmission / 15
32 / Engine timing / 20
33 / Cigarette lighter / 15
34 / Engine timing / 15
35 / Trailer receptacle / 30
36 / Fog lights / 15
37 / Radio / 20
38 / Luggage compartment light, central locking system / 15
39 / Emergency flasher / 15
40 / Horn / 25
41 / Anti-lock brake system / 25
42 / Vacant
43 / Vacant
44 / Seat heating / 30

Hope this helps (remember to rate and comme this free answeer).

one is under driver side of dash, the other is behind the battery, and the relay center is in the glove compartment under the bottom panel.

have you located fuse panel? there may be two. check under dash on drivers side, end of dash where the door closes or maybe even in glove compartment

i looked it up and from the picture, it looks like the fuse box is below the drivers dash, on the left side behind a wall panel near the floor next to the black foot rest thing. try and look there

sudden failures are usually the blend door actuator. Unfortunately, you have to remove the dash to get the actuator out. It sits on top of the heater box in the second picture below. I have pasted the procedure below from autozone.com. Please see my tip at http://www.fixya.com/cars/r6235876-no_heat_fan_blowing_cold_air . If you get stuck, please get back to me, and thanks for using FixYa.





1992-98 Vehicles

1. Position the front wheels in the straight-ahead position.
2. Disconnect the negative battery cable.
3. Properly disarm the air bag system; see Chassis Electrical .
4. Remove the right and left mouldings from the instrument panel by pulling up and snapping out of the retainers.
5. Remove the right and left lower insulator panels from the instrument panel.
6. Remove the 5 bolts retaining the lower instrument panel steering column cover and remove the cover.
7. Remove the 2 bolts and reinforcement from under the steering column.
8. Pull up to unsnap the upper finish panel and remove the upper finish panel.
9. Remove the ignition lock cylinder; refer to Suspension & Steering .
10. Remove the tilt lever and the upper and lower steering column shrouds.
11. Disconnect the wiring from the steering column switches and the transmission range selector cable from the column.

Do not rotate the steering column shaft.

1. Place a cover on the front seat to protect it from damage.
2. Remove the 4 nuts retaining the steering column to the instrument panel and lower the column on the front seat.
3. Install the lock cylinder to make sure the steering column shaft does not turn.
4. Open the glove compartment door and depress the sides inward.
5. Lower the glove compartment assembly toward the floor.
6. Through the left side of the glove compartment opening, remove the 2 bolts retaining the instrument panel to the dash panel brace.
7. Remove the right and left cowl trim panels.
8. Disconnect the wires of the main wire loom from the engine compartment on both the right and left sides.
9. Disengage the rubber grommets from the dash panel, then feed the wire loom through the hole in the dash panel into the passenger compartment.
10. Disconnect the wires from the instrument panel at the right and left cowl sides.
11. Remove the 2 lower bolts retaining the instrument panel to the A-pillar.
12. Using the steering column and glove compartment openings, and by reaching under the instrument panel, detach all electrical connections, vacuum hoses, demister hose, heater-A/C vacuum lines and radio antenna.
13. Close the glove compartment door and support the instrument panel.
14. Remove the 5 screws retaining the top of the instrument panel to the cowl top and disconnect any remaining wires.
15. Remove the instrument panel from the vehicle.
16. If the instrument panel is being replaced, transfer all parts to the new panel.

To install:

1. Carefully position the instrument panel in the vehicle and install the 5 screws retaining the top of the instrument panel to the cowl top.
2. Open the glove compartment door and depress the sides inward to lower the glove compartment assembly toward the floor.
3. Attach the radio antenna and all electrical connections and vacuum lines.
4. Install the 2 lower bolts retaining the instrument panel to the A-pillar and tighten to 17-25 ft. lbs. (22-34 Nm).
5. Connect the instrument panel wires at the right and left cowl sides.
6. Feed the main wire loom through the hole in the dash panel into the engine compartment.
7. Secure the rubber grommets in the dash panel.
8. Connect the main wire loom wires on the right and left sides.
9. Install the right and left cowl trim panels.
10. Install the bolts retaining the instrument panel to the dash panel brace.
11. Close the glove compartment door.
12. Remove the lock cylinder from the steering column.
13. Raise the column into position and install the 4 retaining nuts. Tighten to 15-25 ft. lbs. (21-34 Nm).
14. Connect the transmission range selector cable to the steering column and the wiring to the steering column switches.
15. Install the steering column shrouds and the tilt lever.
16. Install the ignition lock cylinder.
17. Install the upper finish panel.
18. Install the reinforcement under the steering column and tighten the bolts to 7-10 ft. lbs. (9-14 Nm).
19. Install the lower instrument panel steering column cover and tighten the bolts to 7-10 ft. lbs. (9-14 Nm).
20. Install the lower insulator panels and the instrument panel mouldings.
21. Connect the negative battery cable.
22. Enable the air bag system.
23. Check operation of all instruments, lights, controls and the A/C-heater system.
24. Check the air bag indicator operation.

I know on a 83 its located by the glove compartment ,, try looking there

no there is only one fuse and its usually listed under the acc . on the panel most fuse panels are either in the glove box or on the drivers side dash as you open the door or under the dash and some are located under the hood one of these areas is where you will find the panel

The main fuse panel is inside the engine compartment. The second fuse box is located under the drivers side of the dashboard. Remove the fuse box cover (if equipped) by pushing in at both ends and pulling off the cover.

The fuse panel is located below and to the left of the steering wheel by
the brake pedal. Remove the CD stowage box to access the fuses.
To remove a fuse, use the fuse puller tool provided on the power
distribution box cover located in the engine compartment.

Check fuse 47, it is a 20 Amp

Here is a link to your owners manual on PDF

http://www.motorcraftservice.com/pubs/content/~WO5FOC/~MUS~LEN/41/05focog4e.pdf