Need instructions on how to get to and remove cabin micro filter

Follow the link. BMW 5 Series Cabin Air Filter Micro Filter DIY Replacement Removal And...

it should be located under the hood somewhere on the firewall.If in doubt the parts store where you get the filter can look it up in the same book the look your filter up in

Usually the cabin air filter is located under the dash, under the glove compartment.

Hello, I'm sending you exploded view of the glove box and the in cabin micro filter cover illustration. Remove the two upper screws on the glove box and carefully pry metal clips loose.
Disconnect glove box lamp electrical connector. Do not let glove box assembly hang from glove box lamp harness.
Remove three lower screws and remove damper clip from glove box door. Separate glove box housing and passenger instrument lower panel.
Remove three screws and remove in cabin micro filter cover.
Remove in cabin micro filters from front heater and cooling unit assembly.
Note When installing two new in cabin micro filters ensure that the filters are facing in the direction indicated by the direction arrow for the airflow. Direction arrow is printed on side of in cabin micro filters.
Install in cabin micro filter cover. Reinstall glove box.
Thanks

The cabin filter is located just behind the glove box and the trim panel underneath. You'll nee to remove the trim panel & the glove box, then looking forward, you'll see the tray going horizontally on the heater assembly. I seem to remember it was held in with 2 screws.

I bought the filter and the complete instructions came with it, got it on eBay. I had replaced them on other cars before, this is realatively easy and definitely not worth paying more for the filter than necessary or the labor cost.

good luck

I'm going to send you exploded view of the glove box and the in cabin micro filter cover illustration. Remove the two upper screws on the glove box and carefully pry metal clips loose.
Disconnect glove box lamp electrical connector. Do not let glove box assembly hang from glove box lamp harness.
Remove three lower screws and remove damper clip from glove box door. Separate glove box housing and passenger instrument lower panel.
Remove three screws and remove in cabin micro filter cover.
Remove in cabin micro filters from front heater and cooling unit assembly.
Note When installing two new in cabin micro filters ensure that the filters are facing in the direction indicated by the direction arrow for the airflow. Direction arrow is printed on side of in cabin micro filters.
Install in cabin micro filter cover. Reinstall glove box.

The cabin air filter is located behind the glove box, you will have to remove the glove box, behind the glove box is a cover about 1" high and 7" long, remove that cover and you will see a tray that holds the cabin air filter, remove the tray and you can replace the paper cabin air filter, I recomend using a Toyota cabin air filter, the Toyota cabin air filter is a HEPA air filter and is available at any Toyota dealer for about $ 30

Remove instrument driver lower cover.
Remove accelerator pedal assembly.
Remove filter cover and then remove in-cabin microfilter.

Purchase a Purolator Cabin Filter for your Impala. It comes with complete instructions. The filter is located below the windshield, passenger side. The black plastic cover must be removed to access the filter. You simply raise the hood and remove 3 plastic clips, and the washer hose from it's holders. This will allow you to remove the plastic cover over the filter

Please rate this

The filter comes with the instructions. I just did it last night to my Honda. It is behind the glove box. You need to remove the glove box, cut a plastic beam out, unscrew the metal support beam and then open and r/r the filter. The instructions don't mention that you need to remove the trim that covers the little fuse box located on the side panel--there is a plastic retainer that you unscrew by hand and then it all comes off easiliy!