I HA NO DIAGRAM BUT IS VERY EASY I THINK YOU WILL HAVE NO TROUBLE DOING IT THE TANK IS HOLDTO THE FRAME BY TWO STRAPS EACH ONE HAVE A BOLT AT THE END YOU WILL NEED A 15 mm DEEP SOCKET, SECURE TANK PRIOR TO REMOVE STRAPS SO IT WOUN'T FALL,LOWER TANK SO YOU CAN DISCONNECT ELECTRIC CONNECTOR AND FUEL LINES YOU WILL NEED A DISCONNECTING TOOL FOR FUEL LINES THIS IS A VERY INEXPENSIVE TOOL JUST PUSH IT IN THE GAP OF LINE CONNECTION AND PULL LINE OUT THE PUMP IS LOCK IN THE TANK BY A LOCK RING YOU WILL NEED TO PUT PRESSURE OR TAP WITH SREW DRIVER OR CHISEL MAY BE A HAMMER AFTER YOU REMOVE THIS RING THE PUMP IS FREE JUST SLIDE OUT. TO INSTALL JUST REVERSE PROCEDURES YOU WILL NOT NEED THE DISCONNECTING TOOL AT THIS TIME. HOPEFULLY THIS HELPS IF SO PLEASE CHECK IT IN CORNER OF THIS BOX IF YOU NEED FURTHER ASSISTANCE I'LL BE HAPPY TO HELP THANK YOU FOR YOUR TIME
Testimonial: "Thank you"
gettint the pump out of the tank on 2001 Silverado was not much of a problem.
Putting the new pump in the tank has been a devil of a problem; the lock ring
is too high and will not go into the slots no matter how hard I press down on
the pump; it's like the rubber gasket it too thick! I even tried the old gasket
but could not even get it to work!
sounds like it may be out of alignment, since most pump assemblies have only one possition to fit in .
try turning the fuel pump assembly applying pressure to it should find the rigt possition with very little effort , look for a square like key on the base and a squer like cut in the tank and fit it right in it .
×
557 views
Usually answered in minutes!
×