At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Hi i want to change the starter motor in my 97 hyundai lantra manual. I have the replacement starter motor and have the car on stands. I have identified the starter motor on the car but i can only see one of the fixing bolts. Do I need to remove the extractors to remove the second bolt? Is there any other parts that need to be removed? Any help is much appreciated
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Follow the lead from the positive lead from the battery.This will get you to the starter motor.Get rid of all the stuff, battery etc. to make it easier to get at.Hope this helps
Revised Bulletin This TSB supersedes the Cylinder Head Bolt Torque Specifications previously
described in TSB # 96-20-003, TSB # 96-20-003-1 and TSB # 97-20-004.
DESCRIPTION:
This bulletin provides torque specification corrections to the 1996 and 1997
Elantra Shop Manual, 1997 Elantra Service Data Book, 1997 Tiburon Shop Manual
and 1997 Tiburon Service Data Book.
Please record the corrections (listed) in the appropriate manuals and write
the TSB number on the bottom of the pages listed below for future reference.
CYLINDER HEAD BOLT: (M10) 30 Nm (300 kg.cm; 22 lb.ft) + (60°to 65°) +
(60°to 65°) (M12) 35 Nm (350 kg.cm; 26 lb.ft) + (60°to 65°) + (60°to 65°)
They use throw away bolts. One use only, so don't reuse your old ones. You will need new ones. The smaller bolts 1st torque setting 22Ft/Lbs and the larger 26ft/lbs, the 2nd torque setting 60 degrees both bolt sizes and the 60 degrees for the third.
If the replacement thermostat is good, and installed properly, then the temp sensor might be bad. I hate to tell you ($$$$$) but waterpump could be bad (more expensive)
hi there! i was a master tech 4 hyundai, first of all has the atf fluid been changed and at the correct level. or have you had the multifuntion switch checked? please feel free to contact myself and i will advise you as required with my exsperience
The baseline idle is set too high. Meaning someone has screwed the idle screw out too far. Probably because the Idle Speed Control Motor is dead. Same thing happened to me on the same model car. Replacing the ISC Motor is extremely easy to do, a replacement cost me $135AU.
×