Question about Nissan Frontier

1 Answer

I have a 2006 Nissan Navara. The blower resistance board is defective. I intend building a replacement board using high wattage resistors. Does anyone have a resistance board layout with resistance values between the pins? A simplified electrical schematic with the resistance board & blower speed control would be a bonus!

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Nissan Master
  • 30,805 Answers

Usually the non resettable fuse blows due to over heating caused by tight motor bearings.
Replace the 125 degree C fuse link.

Posted on Nov 21, 2017

Ad

6 Suggested Answers

Anonymous

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 132 Answers

SOURCE: 2000 Pontiac Grand Prix interior fan speeds 1-4 not working

Check the ground, the resistors are accully resisnting the Negitive Current.

Posted on Jul 30, 2008

Anonymous

  • 73 Answers

SOURCE: 2000 cherokee sport blower motor control

It is a bad blower motor resistor and it is mounted on the bottom of the A/C heater housing on the passenger side of the vehicle under the glovebox area. Hope this helps. Please rate this a fixya if it helps. Thanks.

Mike

Posted on Sep 13, 2008

keemo68

Ronald Mueller

  • 1263 Answers

SOURCE: 2004 Chevrolet Silverado Heater/AC Blower on without Ignition ON

there is no relay for the heater fan it's a 15 amp fuse and is on the accessories circuit. the reostat is responsible for all 3 speeds .with the key off there should be no voltage to the blower motor whether the fans speed fan switch is on or off. the fuse will be located in the fuse paneleither on the drivers left side in the dash or underneath the dash in the fuse block. you have a short in the harness that is under the dash and most likely it's a bad plug on the harness. your going to have to do some searching but that's where the problem short is... please rate

Posted on Oct 04, 2008

Anonymous

  • 71 Answers

SOURCE: location of blower resistor

The resistor is located on the blower housing on the firewall under the hood under the relay center boxes.

Posted on Dec 01, 2008

Anonymous

  • 82 Answers

SOURCE: AC blower motor resistor Nissan Maxima 2000

yeh its located under the passenger side glove box,its in the heater box beside the heater motor ,,2 scews hold it in and it looks like a credit card when its out,,,,

Posted on Apr 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I replace a blower resistor in a 2002 Nissan Sentra GXE?


Right next to the blower motor is the resister beneath the glove box,just remove connector,then 2 screws,can't tell by looking at it if it's bad,here's a link to what it look's like. Duralast Heater Blower Motor Resistor JA1625 2002 Nissan Datsun Sentra...

Sep 12, 2014 | 2002 Nissan Sentra

2 Answers

My 2006 blower fan switch only has a high. As soon as I turn it on it goes to high. Would this also be the relay?


this sounds like a bad blower motor resistor board that has gone bad. they are designed to work only on high if they go bad so you will still have the blower to defrost the windows.

Sep 10, 2014 | 2006 Nissan Titan

2 Answers

Location of the resister for the heater fan 350 ford 2006


Its under dash panel.

HEATER BLOWER MOTOR


Its faulty blower motor resistor. The low and medium speed on blower motor is controlled by resistor and its actual speed is high. So because resistor is not working, blower motors actual speed which is high is working.


It can be faulty blower motor or faulty blower motor resistor. Get the blower motor inspected. If it's faulty it has to be replaced.


=======

For blower motor testing and replacing, check the link below: ----

Blower motor Testing/replacing for all vehicles?

http://repairhelpcenter.blogspot.in/2012/02/blower-motor-replacing-for-all-vehicles.html

------------

These will help.

Thanks.

Nov 28, 2012 | Ford F-350 Cars & Trucks

1 Answer

93 nissan maxima heater blower motor works on high only


You have a defective heater blower resistor, the part is located next to the blower motor in the air ducting that it uses to cool the resistor.

Aug 24, 2012 | Cars & Trucks

1 Answer

My 1995 Nissan Sentra heater fan only worked on high, so I replaced the blower motor resister and now it only works on the first 3 settings. Any idea why?


did you install the right resistor, or the resistor is defective, many problems with aftermarket resistors, try a dealer resistor.

Jan 20, 2010 | 1995 Nissan Sentra

2 Answers

Heat & A/C Blower Controls Inop. 2003 Dodge Dakota 6cyl


The resistor will cost you 12 dollars at your local dealership. It's located under the passenger side dash and is very easy to replace. The resistor installed at the factory is defective and the new one from Mopar is the correct resistor. It would be worth you while to replace it now while you're working on the blower motor. The blower should still work on the high setting, even with a bad resistor but, replacing the resistor may fix the problem.

Sep 19, 2009 | 2003 Dodge Dakota Club Cab

1 Answer

AC is stuck on high on my nissan titan 2006. I have heard it may be the resistor or the control panel


The blower resister is near the blower motor,mounted on the outside of the blower box,but actually goes inside the blower box.It~s function actually is to give the blower motor lower speeds.If it is only working on high,then this is the problem.If it works on high when you select a lower speed,then there is a high blower motor relay that is stuck in the closed position .Replace the relay.

Sep 09, 2009 | 2006 Nissan Titan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...