SOURCE: 06 PT Cruiser - Stalling - Rough Idle
HI;
I AM A CHRYSLER PARTS/SERVICE MANAGER AND HAVE SEEN THESE TURBOS BLOW INTAKE TO PLENUM GASKETS. WE ARE A SMALL DEALER AND HAVE SEEN 3 HAPPEN AND ALSO WAS VERY DIFFICULT TO DIAGNOSE. WE WERE ABOUT TO PULL THE HEAD ON ONE WHEN WE FOUND THE GASKET SUCKED IN. PART IS CHEAP AND REPAIR NOT TERRIBLE .HAVE YOUR TECH SPRAY CLEANER AROUND SEAM BETWEEN INTAKE AND PLENUM ENGINE SHOULD DIE DOWN WHEN YOU HIT THE LEAK
SOURCE: 2004 chrysler pt cruiser starter motor removal
You may sneak it out with small fingers with out pulling out the starter.
If starter removal is required,Just unhook the battery cables,Remove the 2 bolts holding the starter on.
Please rate this a fixya
SOURCE: Replacing 2004 PT Cruiser Starter
He can do it. Tell him to just be patient (everything is a tight fit in a PT) and remember to disconnect the battery first. No special tools are required. He may have to move a bracket or two for access. It lives on the left side (front) of the motor and easiest to get to from underneath.
SOURCE: I hace 02 pt cruiser. while in reverse engine shut
My 2002 PT Cruiser will stall when place in (DRIVE), it starte-up with no problum and the rpm go 2 click up and down.
631 views
Usually answered in minutes!
×