I have a 97 Oldsmobile Aurora, how do i remove the Ignition Switch and when i do get it out will it work in another olds aurora , so basically i want to put the 97 switch in a 95

How to Reprogram the Ignition Key for an Oldsmobile Aurora

www.ehow.com > Cars

How to Reprogram the Ignition Key for an Oldsmobile Aurora. The Aurora is ...Replace the ignition switch in a 2002 Oldsmobile Alero after a thorough trouble-shooting session to eliminate issues with voltage, shorts, faulty grounds... How to ...

How to replace an ignition switch in a Oldsmobile Alero ...

? 14:05
https://www.youtube.com/watch?v=5FKwU467PKU
Mar 10, 2012 - Uploaded by BuckeyeBryan
How to replace an ignition switch in a Oldsmobile Alero. ... Showmore ... How to diagnose a bad starter, ignition, neutral safety switch!

GM How to Replace Ignition Lock Cylinder - YouTube

located on the transmision. wher the shift linkage gose into the trann.

how do i get my alarmsystem disconnect on a 97 aurora olds

According to my parts guide, the fuel pump for your 97 Olds Aurora fits only that and the 97 Buick Riviera's and nothing else. The pump for a 99 Park avenue comes up as a different part number. Hope this helps!

clean the key

It could be the Ignition Switch. If, when it cuts off, you notice your gages, etc go off, then you are losing ignition power. If not, then maybe I would look at the crankshaft position sensor, etc. This should through some sort of code though.

You will need a special tool for that. An ac clutch puller is required, do not forget to evacuate system before servicing

Pu the key in it and put the cylinder in the hole in the on position and turn the key back to accessory position . pull on key to verify it is locked in.

did you get the tumbler from the dealer because some have coded keys

it could be a bad crankshaft sensor or a bad coil on the aurora on the cutlass there is a kill switch but i dont remember where its located