I have a shogun 3.2 did import year 2000 auto. i have got two problems.when i tow my caravan it keeps over heating if i keep the speed down to 45 mph it runs ok but as soon as a i approach a hill it overheats again and i have to creep along to stop it overheating. the other problem is nothing to do with towing the shogun seems to have a mind of its own when driving on uneven roads or you drive over ruts in the road.it feels like it has rear wheel steer .it seems like i am constantly correcting the steering to keep it in a straight lineon motorways its fine no props at all.i have tried the following different tyre pressures had the tracking done by lazer.changed one front wheel bearing checked all the joints for wear or play still nothing any help would be appreciated by the way its only done 70000 miles thanks Richard
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Yea! I'd like to see the answer to this also!
My Ford Explorer 2000 does the same thing going up hill. Especially with a loaded trailer on.
Local mechanic had it for the day and couldn't put his finger on it.
I can alleviate the problem by turning the AUTO Trak knob to 4x4 Hi while driving and the jerking stops.
I'll keep an eye here to see what others think
Cheers
Trevor
When the transmission is in "tow" mode, the converter is unlocked. That causes the engine to run at a higher RPM but also since it's actually slipping internally (by design), it builds heat. If your radiator is the least bit internally obstructed or if you don't have a large enough transmission cooler (mounted externally), or, a combination of both items, everything will get hotter than it should be. Heat is especially bad for your transmission. The fluid chemically breaks down resulting in clutch slippage and burning. If you do a lot of hauling, I'd get the largest trans cooler available making sure it's attached to the return side of the one inside the radiator and also change the fluid to a good grade of synthetic (resists heat damage far better than conventional fluid). Even if you think it's clean, I'd also flush out the radiator just to make sure.
The rear wheels on this car are free rolling. With the front wheels up on the tow dolly and secured with the straps provided you should have no problems. Follow the tow dolly instructions such as release the emergency brake, place selector in neutral, and don't drive over 45 mph. You will get to where your going safely. GOOD LUCK.
Hello. Welcome to FixYa. I am Toyota Ed, and I will be assisting you today.
The Overdrive function allows the transmission to shift an extra time, sort of like selecting 5th gear in a 5 speed manual transmission. The Overdrive, when used, will save you gas, as the engine is no longer maintaining a high RPM at normal driving speed. Look at the tach whilst driving about 45 mph, and engage/disengage the OD. You will see the tach RPM raise when the OD is off.
More RPM = lower fuel mileage,
The ECT is a different circumstance. The ECT button is used primarily when you have a heavy load in the car, or are towing something. All the ECT button does, when it is engaged, is lengthen the shift points as the transmission upshifts. Normally, the transaxle will shift into 2nd gear at 18-21 mph. When the ECT is engaged, the transaxle will shift in the area of 22 -24 mph. In short, the ECT just makes the time to the 1-2 and the 2-3 upshift longer, to compensate for the additional load being carried/towed.
You need to back off the transmission kickdown cable. It is located just beside your throttle cable near the air intake duct. You may have to remove the black plastic cover to gain access. Just back of the adjusting nuts about one quarter inch at a time until it operates correctly and lock them down at that point. Thank you, Dana
First I need to ask is it a 4 speed or a 3 speed transmission. If it's a 4 speed when driving down the road pull it from drive to third gear. You shpuld hear the engine speed up if it does not then that means you have on 4th gear and you will have to take it to a transmission shop. If it's a 3 speed then just count the shift points if all 3 gears are present then drive down the road and see if the van goes into tcc. When you mean the rpms are high how high are they.
normally should take 6-8liters when empty.If it is making those noises keep a tow truck on speed dial.Dodge does not make a very strong transmission.Could be that you just need the bands adjusted but I suspect you either need to rebuild or replace it
×