Question about 1996 Dodge Neon
Makes no difference where you got the vehicle, A recall is a recall no matter who you are. If you have this recall problem, take it to any dealer and they cannot refuse you.
Posted on Nov 08, 2017
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
have you got a dimmer switch on your model to dim the dash lights. if you have it may be faulty. link the cables together if the lights work the switch is faulty. if you have not got a dimmer switch
your printed circuit on the back of the dash may be faulty or the plug in the back of the dash is not pushed all the way in. hope this helps
Posted on Apr 16, 2009
These vehicles seem to have a problematic short, my grandfather has the same vehicle with the same problem, i found the short under the carpet on the driver side of the vehicle, under the gas pedal, sometimes wires can crack and break.
Posted on Jun 01, 2009
IF YOU REMOVE INSTRUMENT CLUSTER AND UNPLUG IT,PLUG IT BACK IN AND UNPLUG IT AGAIN..DO THIS A FEW TIMES..IT SHOULD CLEAN OFF SLIGHT OXIDATION ON CONNECTOR TERMINALS..HAVE SEEN THIS BEFORE..I ALSO THINK REPAIR CONNECTORS AVAILABLE FROM DEALER
Posted on Jun 21, 2009
Tips for a great answer:
Oct 10, 2018 | Dodge Cars & Trucks
Nov 02, 2016 | Chevrolet Cars & Trucks
Apr 08, 2016 | 1996 Nissan Pickup
Jul 01, 2015 | Cars & Trucks
All 1992 Chevrolet vehicles are equipped with electronic speedometers. If you have to fix the speedometer, you must pull out the gauge cluster, reach behind it and rewire the speedometer. You can save money by performing the task in your garage or driveway and the entire process should take less than 30 minutes.
Park the Chevy and turn off the engine.
Remove the two screws from the dash above the steering wheel with a Phillips screwdriver. Pull off the dashboard. Lower the steering wheel as far down as it will go.
Remove the screws from the gauge cluster; there is one screw in each corner and they can be loosened with a Phillips screwdriver.
Pull the gauge cluster toward you and reach behind it. Connect both of the wiring connectors at the rear of the cluster to the gauge cluster itself. The left wiring connector is for the speedometer.
Reinstall the gauge cluster and its screws. Reattach the dashboard above the steering wheel and secure its screws.
Jan 11, 2012 | 1992 Chevrolet K1500
Mar 24, 2011 | 2004 Dodge Ram 1500
Mar 07, 2011 | 2000 Chevrolet Silverado 1500
Jul 29, 2009 | 1998 Nissan Frontier
Nov 22, 2008 | 1996 Volkswagen Jetta
144 people viewed this question
Usually answered in minutes!