I need the torque specs for a 6 cyl 2004 Dodge Dakota 2 wheel drive- front wheel hub. In inch-lbs if possible.

Wheel Bearing and Hub Assembly - Front (MPA WH515006)

Wheel Hub Assembly Axle Nut Torque Spec: 180 ft-lbs / 244Nm, tighten further to align cotter pin with hole. .

Stabilizer bar to frame: 45 ft lbs
Upper link nut: 27 ft lbs
Lower link nut: 35 ft lbs

get the exact specs from the workshop manual

The hub bearing retaining bolts are 150 ft. lbs the center axle nut primary torque 135 ft.lbs rotate 5-10 times increasing torque by 50 ft.lbs until final torque of 265 ft.lbs is reached

The torque for the hub bolts is 120 ft. lbs
The torque for the axle nut is 185 ft. lbs.

Here are the specs you're looking for:
• Font axle to hub nut torque 185 ft-lbs
• Front hub bearing bolts 60 ft-lbs
• Caliper housing bolts 125 ft-lbs
• Caliper guide bolts 26 ft-lbs
• front spindle hub nut 97 ft-lbs
• lug nuts 100 ft-lbs.

If you are talking about the 3 bolts on the front wheel hub bearing assembly, then between 85 and 90 ft lbs

Caliper Bolts Torque ...... 24 ft. lbs
Hub/Bearing Bolt ........... 122 ft. lbs
Hub/Bearing Nut ............ 180 ft. lbs

Below is a chart from the Dodge service manual. The correct torque for the front wheel bearing is 163Nm or 120ft lbs

Head Torque sequence Step 1: torque to 50 Ft/Lbs Step 2: torque to 105 Ft/Lbs recheck final torque in sequence.

Torque intake manifold: Step 1: 12 inch/Lbs, (hand tight) Step 2: 72 inch/Lbs, (6) Ft/Lbs Step 3: 12 Ft/Lbs
torque intake plenum: Step 1: 24 inch/lb (hand tight) Step 2: 48 inch/lb (4) Ft/Lbs Step 3: 84 inch/lb (7) Ft/Lbs (To torque bolts, start in center using crisscross pattern)