SOURCE: 1995 Ford Ranger ( engine light ) and stuff need help plz
if your obd2 scanner fits the connection you have obd2, obd1 connector is way differnt.
your code p1443
Control System
Canister Purge
Valve (Mechanical)
Malfunction
Monitors the fuel vapor
flow between the
engine intake manifold
and the EVAP
canister. The system
failure occurs when a
leak or blockage
between the intake
manifold, the EVAP
canister purge valve
and the EVAP canister
is detected by the
PCM.
l Pinched, blocked or
plugged fuel vapor
tubes/hoses (except
between fuel tank and
EVAP canister)
l Damaged EVAP
canister
l Disconnected, cracked
or cut fuel vapor
tubes/hoses (except
between fuel tank and
EVAP canister)
l Damaged EVAP
canister purge valve
Check for audible vacuum
noise in the engine
compartment or significant
fuel odor in the engine
compartment or near the
EVAP canister.
This link has all the codes you need.
http://rockledge.home.comcast.net/~rockledge/RangerPictureGallery/DTCs.pdf
SOURCE: I have a "check engine"
the ck eng light is displayed because ther is an issue with a computer controlled component such as eng sensors or egr system.it will have to be scanned to see what part is failing then repaird as needed.it will also have to have the codes that are stored cleared with a scan tool.before test drive to see if repairs are done proper.
SOURCE: 97 ford ranger/check eng. light on/P1443 DTC
P1143 Air assist control valve range/performance
Could Be your mass air flow sensor. Start there.
SOURCE: 2007 ford ranger 3.0 eng. codes po0301 4cyl miss
PO 300 Codes are cylinder misfires,not injector or egr
Coils,Coil Packs, Ignition,is where you check
- well you need TO CHECK IT AND GO TO AUTO ZONE ...
134 views
Usually answered in minutes!
×