Big ends torque settings head torque settings

SOURCE: hyundai elantra 1.6GLS J2 torque settings

dear friend:here follows the settings in need:
cylinder head-30-35 nm + 30-35 + 65deg + 65deg.
mains-30nm +65deg
big ends- 1 - 26nm 2 - 52NM
fly-wheel -130nm
cam-sprocket - 100-120
crank-pulley - 170-180
cam caps -15nm

Michael Grey

• 365 Answers
• Posted on Jun 20, 2009

SOURCE: engine bearing torque settings big end and main bearing

4 cylinder correct?

SOURCE: cylinder head torque settings for a toyota 1493cc

If you have a vehicle application for the motor you can get a Haynes or Chilton manual from your local auto parts store. They usual run around $30.

SOURCE: need torque settings for big end and main bearing

big end - stage one 18-22 Nm. stage 2 40-50 degrees
main bearings stage 1 20 Nm stage 2 90 degrees

steve morris

• 1675 Answers
• Posted on Apr 07, 2010

SOURCE: whats the torque setting for big end bearing bolt

hi big end bearings are two stage, 25nm leave ten mins, then 49nm cylinder head bolts three stages 20nm leave ten mins, 40nm leave ten mins then 60nm check after 5,000miles hope this helps