SOURCE: 2004 Dodge Ram Srt 10 problem
need to check your intake air temp sensor and need to know what engine temp the computer is seeing if it thinks it is -30 it will flood it out
SOURCE: Viper Alarm System problem
Look for a push button under the dash, should be black, turn key on and hit button.. should go into "valet mode".. hopefully you will be all set...
SOURCE: need a wiring diagram for Hyundai Sonat 2002
Go to www.hmaservice.com and register( Vehicle by VIN). Afterward, you have access to shop manuals, service bulletins, wiring diagrams, etc. about your vehicle.
SOURCE: I have a viper alarm on my car that wont shut off
was it a professional or shade tree install? the following is off vipers website:
disarming without a remote control
This feature allows you to disarm the security system without the
Remote Control should it be lost, damaged, or disabled. In order to
disarm the system without a remote remote control, you must have
the vehicle’s ignition key and know where the Valet button is
located. Be sure to check with the installer for the location and the
number of presses of the Valet button required to disarm the system.
To disarm the security system,
turn the ignition to the ON position.
Press the Valet button the
preset number of times (one to
five times) within 15 seconds. After five seconds the system will
disarm. If the system does not disarm, you may have waited too long;
turn the ignition off and on and try again.
if that doesn't work try this other
valet mode
You can prevent your security system from automatically arming
and triggering by using Valet Mode. This is very useful when
washing the vehicle or having it serviced. In Valet Mode, the
security system will not arm, even with the Remote Control, but
all convenience functions (door locks, trunk release, etc.) will
continue to work normally.
To enter or exit Valet Mode:
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet
button within 10 seconds.
The status LED will light solidly if you are entering Valet Mode,
and it will go out if you are exiting Valet Mode.
SOURCE: How do I reset my Dodge Viper 1994 alarm? My
Try locking and then unlocking your car with the key in the drivers door. This should reset it
67 views
Usually answered in minutes!
×