How to replace the headlamp bulb for my 2005 mitsubishi outlander

Type or copy and paste this link into YOU TUBE.
Hope this helps.

MITSUBISHI OUTLANDER WIRING DIAGRAM

No. Remove the socket cover. Then remove the bulb. You have to remove the bumper to replace the entire headlight assembly, but not for just the bulb

for better result download the pdf file
MITSUBISHI OUTLANDER SERVICE REPAIR MANUAL 2003 2004 2005 2006 DOWNLOAD

I would say it is part of the whole headlamp assembly and cannot be removed separately.

The 2003 Outlander utilizes replaceable (9007) headlight bulbs. If you're looking to replace the bulb(s);
1. Raise the hood.
2. Remove the plastic cover at the rear of the headlamp assembly by rotating it counterclockwise, and pulling it off. This will allow access to the headlight bulb.
3. Twist the bulb socket counterclockwise in order to remove it from the headlamp assembly. Pull the old bulb out of the socket, and use a clean cloth to install the replacement bulb. Do not touch the glass of the new bulb.
4. Place the socket back into the assembly, and twist it clockwise. Reattach the plastic cover, and close the hood.
Are you needing DIY instructions for replacing the entire headlamp assembly? Left (driver) or Right (passenger)?

You have to remove the head light assy from the body,
on almost all vehicles today

Then you can somewhat easily remove the lamp
socket from it & then the lamp/bulb it'self

Have to look for screws or bolts holding it on

May have to remove a few things to get to the
bolts.

You could look on You Tube--- for Video of it
being done

Sometimes bulbs will just go out like this, or it may have been a bad one to start off with. Try replacing the bulb again, and if the problem persists, contact the Dealership.

I’m happy to help further over the phone at https://www.6ya.com/expert/jeremy_69f3cc28d95bf514

maybe the bulbs the filament

It takes special equipment that is expensive. Take it to the the dealer or a body shop.

you might want to check the fuses first, if they are all good then
check the switch which is located in the back door jam area. You should be able to unscrew or get to the switch back easily once there connect the two wires together and see if it lights.