2006 Kia Rio Dash Light check Engine light will come on and then start flashing. Also every gauge on the dash will flat line and then return to it typical running position after a gear change. Ex: Speedometer goes to zero, engine temperature gauge goes to coldest position, oil presure will read zero on gauge.

SOURCE: kia rio 2003 radio security code

call the dealer . Tech will give u a code to put into radio

SOURCE: car troubles with my 2004 kia rio

This could be a bad thing or it could just be the guage failed. I would bring it in to dealer and hope you are under waranty meaning under 100,000 miles. And single owner.

SOURCE: Check Engine light

that code definition is "Evap high purge flow fault". It means you may have a problem with the evaporative system. this system routes fuel fumes back to the fuel tank. If you want to try and clear this code, find the radio code for your car and then disconnect the battery for 30 seconds. Reconnect the battery and the check engine light should be out. You will then need the radio code to reset your car stereo. the check engine light may stay off if the condition was a transient one. If not, the light will come back on after you drive the car two drive cycles. That is: two starts, warm ups and shut downs. If the light returns, have a mechanic check it out.

SOURCE: oil pressure gauge on wrong side of pin

pull the cluster out an slip a wire between the clear plastic an just flip the needle back up...i just did this yesterday lol works great now

SOURCE: Tach and speedometer gauges intermittently stay at zero

I had that happen to my Jetta you need a new cluster. This is all the gauges.