SOURCE: 1992 Honda Accord LX Brake Light Switch Repair
Of course you can make this repair! I'm wondering about the faulty bulb that shorted out all the brake lights...not sure if that's what happened. Your brake light switch is located on the brake pedal, up above where your foot goes. It has a plug in connector which you unplug, then loosen the locknut where it attaches to the pedal.Put in the new switch, lock nut 1st, then plug it in. Note that the locknut is the adjustment point that determines when your brake lights go on. Adjust the locknut so that the brake lights go on when the pedal is depressed within 1/2 an inch (13mm)of pushing down on it. If the switch is adjusted without enough play (say 1/8 inch or less), brake lights may flicker on and off when you go over a bump.If over 1/2 inch, brake lights might go on only if great force on pedal is used (or not at all, yikes!).For good diagrams of parts check out South Bay Honda (hondapartscheap)web site. You enter the year, model, engine, and you can scroll thru tons of parts. If you have any more questions, do not hesitate to post it for me. countrycurt0
SOURCE: passenger electric window
Hi Ethel101
I think that what has happened with your vehicle, is that the master (driver control) switch has become defective....If you have a friend who is good with electronics you may be able to ask for help in getting it fixed....otherwise a new unit is needed.
Best regards
Johngee10
SOURCE: 2 dr honda accord power window problem
I wouls suspect you have either a inoperative window regulator (the frame work for the power glass) or a bad power window motor. More often then not the are sold as a single assembly and are not very hard to replace on this vehice.
SOURCE: car brake lights won t turn off when car is shut down Honda accord lx 1992
i just had this happen with my accord..there is a little blue piece that fits behind the brake pedal..overtime this peice can become old and fall off or just deteriorate..u wud have to get a nut and very short bolt to replace this peice behind the pedal..there is a push sort of pin behind the pedal that the blue peice woud control when the pedal is pressed
SOURCE: car brake lights won t turn off when car is shut down 1996 Honda Odyssey
It should be your brake light switch. There is a little plate welded to the arm of the pedal that has a hole with a rubber stopper. The rubber stopper is most likely missing, or damaged. You should be able to take a flashlight and see the plate and the switch. If the hole is plugged up, you will need the brake light switch, if not, replace the plug.
240 views
Usually answered in minutes!
×