Is there any where i can get a diagram for a steering colum for a 1984 gmc sierra classic pickup it has tilt steering and colum is loaded cruise wipers ect. thank you if you are the person who helped me before thank you so much your inform. really helped my email is [email protected]
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
theyve had quite a few problems with the switch on steering wheel but also check for any trouble / pending codes will cause problem with remote start and cruise
Sounds like your ignition/key tumbler is worn. A lot of times tumblers can get worn to the point that the keys will stop
working or work sometimes. Usually the key goes bad first, since they tend to
get the most abuse. It is not expensive to replace. I hope this helps.
>>>>FIRST disable the air bag system You'll need to remove the upper and lower steering column covers. Also all the trim under the drivers side, kneee bolster, etc... The ignition switch has 2 screws holding it on. Remove those screws and all related wiring harness. Then the switch. Here is the procedure from GM......
Place the multifunction lever in the center or the OFF position. Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
Disconnect the battery negative cable. Disable the SIR system. Remove the steering wheel inflator module. Remove the horn plunger contact. Remove the steering wheel. Remove the tilt wheel lever. Remove the ignition lock cylinder. Remove the upper steering column trim cover.
Couldnt find a diagram. Hope this helps.
I think I have what your looking for can I email it to you
William
×