Headlight Adjustment My headlights are askew. How do I adjust them?

Not much on that job. Usually when you buy a new headlight unit they come complete, you just bolt them in.

https://www.google.com/search?q=2002+Chrysler+Sebring+headlight+adjustment+screws

and

https://www.google.com/search?q=2002+Chrysler+Sebring+replace+headlight+assembly

..

Horizontal Adjuster - Lincoln Electric

www.lincolnelectric.com/en-us/.../Pages/product.aspx?...

Lincoln ElectricHorizontal Adjuster. K96. Top Features. Provides crank adjustment of head position. Has 2 in (51 mm) horizontal travel. Standard/Extended Warranty. Industrial ...

Headlight horizontal adjustment - Jeep Wrangler Forum

www.wranglerforum.com/.../headlight-horizontal-adjustment-358953.ht...

Oct 25, 2013 - 27 posts - ‎12 authors
That's when I found the horizontal adjustment! (And just so you know, the vertical adjustment is a silver colored t15 screw at about 10 o'clock on ... LEd headlights horizontal adjustment
6 posts
Jan 2, 2015
Horizontal headlight adjustment
7 posts
Nov 9, 2014
Headlight and Foglight Adjustment/Aiming/Alignment
30 posts
Jul 26, 2014
Headlight adjustment JK
30 posts
Nov 3, 2013
More results from www.wranglerforum.com

Headlight adjustment requires specialized tools.

• Always adjust lights with optical headlight aimer VAS 5107, using detailed aiming procedure and specifications
• Low and high beams are adjusted simultaneously.

Left headlight (adjustment screws for right headlight are mirror image):
1 - Lateral adjustment 2 - Height adjustment

• Access adjustment screws through hole in lock carrier (Phillips head or socket head).
• Turn the adjusting screws for lateral adjustment -1- and height adjustment -2- until the correct setting is achieved.

NOTE: Where equipped, ensure equal movement/function of headlights during automatic headlight range adjustment.

sometimes the headlights stick to the adjusters,just pull/push(wiggle it)to free it, then try setting beams.

Used to adjust headlight beams up or down and left or right, it's located above and to the side of light behind the headlight retainer.

They will probably be inset adjacent to the headlight. You'll find a horizontal and a vertical adjusting screw, with small springs behind them. Some cars come equipped with a small level (like a carpenter's level) attached to the top of the headlight under the hood to help you get the correct adjustment.

There are two adjustment points (screws). For example left headlight: you will see one point near the end of left wing, at bottom side through a wing hole. This is for vertical plane headlight beam adjustment (up-down). Another one point is against water radiator side. This is for horizontal plane headlight beam adjustment (left-right).
Please Rate my Response! Thanks!

I had a similar problem on my 04 expedition. I just bought it and the headlights were aiming too far down. A rather larger gap was noticeable between the headlight and the hood. The so called adjustment bolt did nothing. I removed the headlights and found 2 issues. On the adjustment bolt there is a washer. Make sure when you re-install the headlight the washer sets on top of the plastic slot and is visible when looking down behind the headlight. Without the washer being in the correct location it will not tighten the headlight in place.
Second I found the adjustment bolt adjusted nothing. It merely tightened the headlight in place. What I had to do was to loosen this bolt and physically move the headlight into place and the re-tighten the bolt. Hence the slot is the adjustment. Turning the bolt CW or CCW did not move the headlight.
I tried several things trying to figure why the lights would not move until I realized I could move the light with my hands and tightened them in place using the adjustment bolt.

This may not be your issue but I found the owners manual instructions to be useless.