Valve clearance Hi I would be most grateful if you could tell me what are the clearances, in mm, for the inlet & exhaust valves for my suzuki samurai SJ 413. Many thanks Nane M

valve clearances sohc 4g63 carb motor both hot and cold

Valve clearance - INLET mm: 0,15 hot
Valve clearance - EXHAUST mm: 0,25 hot
This engine is set hot if you are repairing the engine and have to do this cold
then set to 0.10mm INLET and 0.20mm EXHAUST
Then once hot readjust to specs

The clearances are:
- 0.10 mm cold (inlet)
- 0.25 mm cold (exhaust)

Cold: Intake 0.30mm, Exhaust 0.50mm.
Hot: Intake 0.20mm, Exhaust 0.040mm.

The 2L Toyota engine runs an overhead cam with bucket lifters, and requires removing and replacing of shims to adjust clearances...

1995 samurai. valve lash , right not valve stem to guide clearance.
there are 3 clearances.
http://www.fixkick.com/sammi-stuff/index.html
volume 1
pdf page 111 tells you this (book page C3-53)
the manual is everywhere.

Hi I need the valve clearance for kia k 2700

323 (BF), 1600 F6
Valve clearance - inlet: 0.30 h mm (hot)
Valve clearance - exhaust: 0.30 h mm (hot)
Compression pressure: 14.5 bar

hope this helps.

make sure engine is warmed up. Put cylinder one at top dead center,remove the valve cover,loosen all adjustment lock nuts,adust intake and exhaust valves on cyl #1 and intake valve on #2 and exhaust valve on #3. now rotate crankshaft 360 degrees clockwise, now adjust intake valves on cyl#3 and cyl #4 and exhaust valves on cyl #2 and cyl #4.now tighten lock nuts and install valve cover. specs are intake valves 25mm clearance and exhaust 28mm clearance, use a feeler gauge,heres a picture to show you where to check clearance.

intake- 0.13 - 0 .17 mm
exhaust- 0.16 - 0.20 mm
when engine is cold
head bolts 51 - 54 lb ft

Try this if you have rge 323 BG

Valve clearance - inlet: 0.30 c mm (cold)
Valve clearance - exhaust: 0.30 c mm (cold)

well, I can see ur message has been here for quite some time. Most probably you got the answer to ur request.
I just did the valve clearance on the engine of my SJ413 that has the 1000cc engine of an SJ410 :
When cold: 0.13mm Intake and 0.18mm Exhaust
Engine sounded well and worked fine after that.
Enjoy
Mehdi