I need instructions for replacing the alternator in my 2001 Chrysler PT Cruiser. It would be of great help if you could assist me in this, or point me in the right direction. Thank you.
This instruction is general for all vehicles. i am sorry that i do not have particularly for your 2001 chrysler PT cruiser.
first, identify the alternator.
remove the fan belt on the alternator,
label and remove all wires that is attached to it.
remove all bolts that is holding it.
remove the old alternator.
do the reverse on installing it.
tnx 4 using fixya,
drcool
2001 pt-cruser,alternator removal,so mine was squealing like a pig, took the belts out, started the car with no belts to pi point the noise sure enough Alternator bearing was bad, so after disconnecting the battery,alternator power wire 10mm and the plug(thres a little red safety buttom you got to push for the plug to come out)the next thing is the axle 32mm for the axle nut, 19mm for the steering pinion (use bolt joint remover borrow it from the zone), the top 2 struts bolts once you got that loose now theres room for the axle to come out of the disk(i didn't remove the bottom bolt joint or brake assembly tap the center of the axle were the little indentation is to remove the axle once the axle is out of the disk you can move the disk forward to do this,now you can pry the axle from the transmission what out for the oil spills,axle out theres still no room to take the alternator out,what i did was remove the oil filter and the oil filter bracket 3 9/16 bolts the whole thing came out,plenty of room now to take the alternator out,like butter it only took 3 hours, axle is got to come out and the oil filter and th adaptor that goes in the oil pan,on my way to find a new alternator,it look overwhelming at first ,but is pretty straigth forward, im not a mechanic and if it seems to much for you, theres guys certified for the task or the dealer,but if this helps anyone save a little mula$$$$,it was my first PT-CRUSER ,wear your safety gogles, time to hug the kids with greasy hands,,hope this helps ,tools 32mm,15mm,9/16,1/2,21mm,bolt joint remover,small adaptor to hammer out axle from tire side, big flat screwdriver for the transmission side, think thats it good luck....
4,078 views
Usually answered in minutes!
rear seat operation
After it gets warmed up, it surges at idle about every 15 seconds. I have gotten plugs replaced, their wires too & the throttle body cleaned but the surging is still there? What could it be?
I have the 4 digit code but all it says is wait, code supplied by chrysler
I have the code provided by Chrysler but when entered it tells me to wait
input and output speed sensors have been replaced in trans
how do I replace the oil sending unit
2001 pt cruiser got fuel but don't have spark
2001 pt cruiser Not getting any spark to the sparkplugs
already got the pressure hose but need to know how to change it.
I'm told the alternator is fine, but the regulator is malfunctioning. Cant replace one without the other?
change alternator
I keep blowing the fuse for my wipers and directional.
How to replace transmission mount p
2001 pt cruiser
×