Hello,
I hope this info helps.
NOTE: This is the only information provided by the manufacturer for clearing diagnostic trouble codes.
CLEAR MEMORY
After eliminating problem as per trouble code, clear memory as follows:
Make sure ignition switch is ON (and engine off). Connect one DIAG. terminal (1) on diagnosis connector (2) terminal No.1.
where warning light is flashing, connect the other DIAG. terminal (3) on terminal No. 2 for at least three seconds . After memory is cleared, normal warning light flashing rate resumes. (Warning light flashes every 0.6 seconds (ON-OFF operation.) Memory cannot be cleared if any problem exists.
After clear memory and then DIAG. terminals (1) and (3), extract from diagnosis connector (2)
Indicator may appear if there is a particular sensor fails.
Try resetting it using the following technique.
Sometimes the problem could be solved.
Advantage is you could use this technique in the future too.
If you can get an OBD 2 scanner off eBay (US$ 6), you could be able to communicate with your car ECU (Electronic Control Unit) using the smart-phone app.
So that, there is a chance to CLEAR all the error indications.
After that, still problem persists, it means the vehicle need full scan (you can't do this at home, probably seek a vehicle garage).
Clarification:
[email protected]
2,493 views
Usually answered in minutes!
×