Hey the service manual usually has that information: https://www.papertownspdf.com/downloads/hyundai-accent-service-manual/
There is a vent that allows vapors to escape while we refill our gas tanks. on your car the vent does connect to a vent valve then to a charcoal canister. you would check the vent valve first then the canister for blockage.
SOURCE: 2000 hyundai accent
Their shop website says below but you can call the service department. usually you want to tighten it just until it starts to not rotate freely then back off just a little bit. It should spin freely.
Hub bearing starting torque [Limit] :
1.8 Nm (18 kgf·cm, 1.33 lbf·ft) or less
SOURCE: Check Engine Light is On 2006 Hyundai Elantra 13,000 miles
An easy fix, if the check engine light is on find an Auto Advance, they can clear the code for you. Any auto parts store may be able to as well, Auto Zone is another one that may be able to help.
SOURCE: I need to change my starter on my Hyundai 1995
first remove the airbox and everything hooked up to the throttle body to see clearly.if youre car is std you must remove 2 bolts holding the clutch cable on the transmission then remove the pin holding it in place once you remove that you will see 1 of 2 bolts holding the starter in place use flash light to see clearly then remove it (14mm bolts i think ).after you do that the 2nd bolt is 4- 6 in. to the right it might be covered in dirt build up so you might not see it to remove it either through the bottom of car or throught the top.
SOURCE: change hyundai accent 2001 front brake pads
Once the car is jacked up, remove the front tires, then whith a 12 wrench key, remove the bolt that is located on the rear side of the caliper, not the one holding the brake fluid line buth the one right next to it. Pry the brake pad holder off and then remove the brake pads themselves. You will need to press the caliper's piston in, to be able to fit new brake pads since new pads will be thicker.
SOURCE: i have a 2002 hyundai accent, i could not pump gas
First GUESS.. replace the charcoal canister after you have cleaned out the hoses between it and the canister. Then blow air between the purge control solenoid valve and the fuel tank.
192 views
Usually answered in minutes!
×