Nissian NXR Coupe with an SR20 Motor

s14 sr20
wire a n/a
wire b -12v eccs power supply
wire c- signal ground
wire d - signal output

Oven lamps are high temperature lamps. Standard lamps are not.

Presume you mean 36" NXR Range _HOOD_?

Page 18 of the manual refers

https://images.homedepot-static.com/catalog/pdfimages/cc/ccc63b98-6785-4c56-b706-b248c4d308a5.pdf

..

Transmission case + 5th gear fix - SR20 Community Forum - The Dash

www.sr20-forum.com > ... > HowTo's > General Maintenance

Dec 28, 2010 - 25 posts - ‎6 authors

How to recognise and repair 5th gear pop-out in a B13 or B14 ... Dont worry about the shift rod linkage and other parts in the old ... bad 5th gear and the notch gets larger and lager then you have no 5th gear . ..... BenFenner's 2000 Black M-Coupe ... NISSANB13 (Sunny/Sentra Genesis) Kumpul2 di sini yuk!


ugh stuck in 3rd gear (5spd LD) P10 g20

21 posts

Jun 13, 2012


No 5th gear

30 posts

Jan 1, 2011


How to: Fix your P11/B15 tranny with QG18 gear ...

39 posts

Sep 11, 2009


Thread: How to recognise and repair 5th gear pop-out in ...

36 posts

May 15, 2009


More results from www.sr20-forum.com

Has a timing belt a non- interferance motor.

Hi Tina,could be your blower motor resistor,it's located next to the blower,2 screws hold it on,remove electrical connector first,take to Autozone and get a new one,if it doesn't fix,they will take back and refund your money Tina.here's a link to the resistor Tina. Duralast Heater Blower Motor Resistor JA1219 at AutoZone com Here's a link showing you the resistor Tina. Repair Guides Blower Motor Removal Installation AutoZone com

check your fuses first, if fuses are good then take a look at the speed sensor, the sensor may be bad, also scan the computer for any stored codes,the codes may tell you the speed sensor is bad,

CA18 motor and box out of S13/S14 will fit into a Samurai with custom mounts.
Here's a pic of an SR20 in a Zook.. It is very similar to a CA18 only slightly bigger.
http://i121.photobucket.com/albums/o221/want33s/SR20%20Zuk/zm1.jpg
I'm not 100% sure but I think the shifter hole in the floor needs to be enlarged rearwards a bit to accomodate the nissan box.

then the water pump must be bad in it .Take the rad cap off and rev motor up if it goes down the the pump is working if it spays of look at the head gasket being damaged .Check and make sure spark plugs are not wet either if one is soaked signs of a leaky head gasket

Hi,

Thermostats are normally inside a small well on the engine side of the upper radiator hose. There would be 3 or so small bolts locking the cover/lid. The lid often also have the outlet where the radiator hose is plugged in.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.