Cars & Trucks - Page 8 - Recent Questions, Troubleshooting & Support
I got a 09 pontiac g6 wont start.there is no crank no clicks when i turn the ignition on but the engine light is on
You have know idea how the starting system works , an with the engine light on your best bet would be to have it towed to a qualified repair shop .
When the ignition switch is turned to the Start position, the body control module (BCM) receives battery voltage on the ignition 1 voltage circuit, and less than 5 volts on the off/run/crank voltage circuit. The BCM supplies voltage to energize the RUN/CRANK Relay 32. The BCM sends a high speed GMLAN serial data message to the engine control module (ECM) that the key is in the start position. The ECM receives the message from the BCM, and also receives a serial data message from the transmission control module (TCM) containing the shift lever position. If the shift lever is in Park or Neutral when ignition switch is turned to Start, the ECM supplies voltage to the START Relay 31. The START relay supplies voltage to the S terminal of the starter solenoid, through the 30 A STRTR Fuse 26, in order to crank the engine.
I need to repair or replace rear brake line on my
I just had mine done in the same location. I sent it to the shop. The fuel tank had to be dropped, plus they found out that the abs pump wouldn't allow fluid back. I had some other work done ...$860 later it back home with me.
Not getting any brake fluid to rear drums to a 1997 Chevy Tahoe
Must bleed air from brake lines. Done so with help of a friend to pump brake pedal a few times and hold while you loosen and immediately retighten the bleeder screw located right where the line enters drum on the back. Use care, as fluid will start to drain out as air is eliminated in line. Do this repeated times. When only fluid escapes you are finished!
I want to bypass a Tata xenon immobilizer
no Year told nor country. 2006 to present Pickup truck small.
NO TATA here in USA, and Made in India. and exported.
but IMMO can not be hacked
that means only ask the dealer if the EFI engine controls cad be
down graded to NO IMMO
ask them , at the least the PCM must be reprogrammed. by them.
Not finding what you are looking for?