Top 20
2012 Kymco Agility 50 - Page 6 Questions & Answers
Need to put my kymco cobra bake together from scrath
Buy a manual. It will save you money in the long run. When you say "From Scratch" do you mean a complete engine rebuild as well? If so you would be better buying a different bike and doing a rebuild in slow time. The only reason I say this is that, if you have you ask for advice in a forum before you have started, then you don't have the skills to do the job quickly.
4/21/2013 9:23:36 PM •
Kymco...
•
95 views • 0 helpful votes
Lost key to moped, how to rewire
The best thing to do is to visit your local Kymco dealer with proof of ownership and the vehicle identification number and have them get you another key. Hot wiring the ignition could be a unsafe thing to do and it could damage other electrical components.
10/8/2012 1:05:39 AM •
Kymco...
•
1,372 views • 0 helpful votes
Cleaned my carburetors and the Jets and now my bike won't start. I have a spark but it won't start.
All questions need FULL 'year make model', as the first 3 words.
Then there are 10,000 categories listed by 'make year model'.
So we are working blind.
Make sure gasoline is being delivered to the carbs by removing the fuel delivery pipe.
Carbs come in different systems. If it has a float bowl on the bottom, tap it with the handle of a screwdriver as it may be stuck.
Turn the engine over. If it doesn't start, remove the spark plug and see if it is wet with gas?
You need three things for an engine to start
Clean gas
A spark at the right time
Compression
You have one thing missing
//
2/21/2024 5:36:50 PM •
Motorcycles
•
26 views • 0 helpful votes
Were do the fuel lines go to on a mountop 150cc
This particular unit has a typical GY6-style engine with a fuel line designated from the gas tank to the carburetor distinguished by an in-line cylindrical fuel filter located near the center of the line. Best to locate the carburetor distinguished by the location of the air filter, there should be a hose going from that unit up into the gas tank.
Ideally, remove the gas tank entirely and it should reveal the gasoline lines directly to the carburetor.
The photo shows the fuel line/filter indicated in red, and the location of the carburetor within the blue indicator.
2/27/2024 7:07:40 PM •
Motorcycles
•
23 views • 0 helpful votes
How do I reset 2007 Victory Vegas 8 ball petrol sensor please.
To reset you need to follow this steps below
1.Turn the ignition switch to the "On"position
2.press and hold the trip reset button on the dashboard until the fuel gauge reset or blinks
3.Release the trip reset button
4.Start the engine and let it run for a few minutes to allow the sensor to recalibrate
5.Turn the engine off and then restart it to ensure the reset was successful
2/8/2024 3:04:00 AM •
Motorcycles
•
24 views • 0 helpful votes
Not finding what you are looking for?