Top 20
National Cycle Chrome Speedometer Cowl Kawasaki Vn2000j-Motorcycle - Page 6 Questions & Answers
Mio Soul i 125 rear axle nut tightening torque value
The tightening torque value for the rear wheel nut of a Yamaha Mio Soul i 125 motorcycle is typically around 70-80 Nm (Newton meter). This torque value is the amount of force required to tighten the nut to the proper level.
It's important to use a torque wrench to tighten the nut, this will ensure that the nut is tightened to the proper torque level without over tightening it, which can cause damage to the threads or the hub.
It's also important to note that the torque value may vary depending on the specific model and year of the motorcycle, so it is best to consult the owner's manual or the manufacturer's website for the specific torque value for your motorcycle.
It's also important to check the torque every time you change a tire or make any adjustment to the wheels, to ensure that the wheels are properly secured and to prevent accidents or damage to the motorcycle.
1/24/2023 3:57:28 AM •
Motorcycles
•
529 views • 0 helpful votes
My piaggo zip 70s kit will not start
There are several potential reasons why your Piaggio Zip 70s scooter may not be starting. Some common causes include:
- Dead battery: Make sure that the battery is charged and in good working condition.
- Faulty spark plug: Check the spark plug and replace it if it is dirty or worn.
- Clogged fuel filter: A clogged fuel filter can prevent fuel from reaching the engine.
- Air filter: The air filter can be clogged, restricting airflow to the engine.
- Poor compression: If the compression in the engine is low, it may not start.
It is difficult to determine the exact cause without more information or a proper diagnosis. The best course of action would be to refer to the manufacturer's manual or seek help from a qualified mechanic who can inspect and diagnose the problem.
1/15/2023 9:48:23 PM •
Motorcycles
•
435 views • 1 helpful votes
What is the wire running up the hood hinge on the passenger side of a 2004 jeep grand Cherokee Laredo
It is difficult to determine the exact purpose of the wire you are describing without a visual inspection of your vehicle, but it is possible that it is a ground wire for the hood light. Some vehicles have a hood light that illuminates the engine compartment when the hood is opened, and this light may require a ground wire to function properly. However, without more information or a visual inspection, it is impossible to say for certain what the wire is for.
2/14/2023 4:01:51 AM •
Motorcycles
•
154 views • 1 helpful votes
Not finding what you are looking for?