20 Most Recent
2007 Suzuki Boulevard S83 Questions & Answers
Battery draining on suzuki S83 boulevard - can ride it for a couple of hours then it just cuts out
Sounds like you need to check the generator and charging circuit.
The bike will start and run on the battery alone until it is drained.
Once a bike has been started the battery power is taken over by the generators power this also replenishes the power lost in the battery when the bike is initially started. If the generator does not generate power the bike will continue to us the power from the battery until it is exhausted and will therefore stop.
A simple test is to turn the bike ignition on and turn the headlamp on (check the brightness of the lamp) Start the bike and re check the brightness of the head lamp, it should be a little brighter if the generator is working. Another test is carried out with the use of a voltage tester (multi meter). Set on dc volts test the batteries voltage eg 12vdc, start the bike and re test the voltage should be around 13 - 14v dc if the charging circuit is working
Front and rear brakes appear
These are for bleeding the air out of you hydraulic brake fluid...
DO NOT PUT GREASE IN THESE!
They are positioned at the top of the brake caliper as that is where the air in the caliper will end up. If you don't know how to bleed brakes, do not touch them.
I'm sure you can read about how to bleed brakes in most Haynes/Clymer type manuals, it takes time and patience. It maybe best to get a mate who knows what they're doing to help/show you the first time.
Where is the rectifier located on my 2004 suzuki katana 600
Behind the radiator on the left side. It is the device with cooling fins, even though the electronic parts are embedded in rubber paste.The location isn't ideal and sudden defects leave people stranded so what people do is relocate the regulator/rectifier to a cooler place. Perhaps to the air inlet, under the air filter. Follow the three, mostly, yellow cables that originate from the stator when you don't find it behind the radiator.
3/24/2024 3:09:20 AM •
Suzuki...
•
Answered
on Mar 24, 2024
Why my Suzuki TF 125 losses power in the midway? What are the causes for such loss of power?
What do you mean by "Midway"? How old is this motorbike? What exactly did you do to clean the carburettor? Is it a new spark plug and a new, clean air filter? Did you empty the fuel tank to remove the fuel tap to clean the filter on the inside of the tap?
Is it doing anything else? Things like - is it hard to start, has heavier exhaust smoke or it has a rough and uneven idle.
2/18/2024 5:20:58 PM •
Suzuki...
•
Answered
on Feb 18, 2024
Bypass immobilizer on 2007 Suzuki R6
You can't, the computerized system is in place to stop exactly what you are trying to do, Steal the bike without the correct credentials. You can't reprogram or over-ride the computer. You need a bike electrician.
12/20/2023 3:33:40 AM •
Suzuki...
•
Answered
on Dec 20, 2023
Where is air/fuel screw on a suzuki vs 800 intruder
The air/fuel mixture screw on a Suzuki VS800 Intruder is typically located on the carburetor. To adjust the air/fuel mixture, you'll need to locate the carburetor and look for a small screw that can be turned.
Keep in mind that the exact location of the screw may vary slightly depending on the model year and specific carburetor version on your VS800 Intruder. Generally, it is located on the bottom or side of the carburetor.
Here are the general steps to locate and adjust the air/fuel mixture screw:
1. Locate the Carburetor: The carburetor is usually positioned on the side or underside of the engine. Follow the intake manifold or air filter housing to find the carburetor.
2. Identify the Air/Fuel Screw: Look for a small screw on the carburetor. This screw is typically flat-headed and may be recessed. It is often located near the bottom of the carburetor.
3.Adjustment: With the engine running at idle, use a screwdriver to turn the air/fuel mixture screw. Turning it clockwise (in) usually leans out the mixture, while turning it counterclockwise (out) enriches the mixture.
4. Listen to the Engine: As you make adjustments, listen to the engine's sound. The goal is to find the point where the engine runs smoothly and the idle is stable.
5. Fine-Tune: Make small adjustments and give the engine a moment to respond before making further changes. It's a process of trial and error to find the optimal setting.
6. Check the Owner's Manual: Refer to your motorcycle's owner's manual for specific guidance on the location and adjustment of the air/fuel mixture screw. The manual will provide information tailored to your bike's make and model.
If you're uncomfortable making these adjustments yourself or if you're unsure about the location of the screw, it's advisable to consult a professional mechanic or refer to the specific service manual for your Suzuki VS800 Intruder.
11/14/2023 2:14:48 PM •
Suzuki...
•
Answered
on Nov 14, 2023
Not finding what you are looking for?