20 Most Recent
2009 Hyosung GT 250 Questions & Answers
Charging the battery
If you have a battery charger, remove the battery cover to expose the
battery terminals then you can connect the battery charge to the
battery.
Make sure you connect the positive lead from the charger to the positive
terminal on the battery and the negative lead from the charger to the
negative terminal on the battery before you power up the battery
charger.
When you have finished charging the battery, power off the battery charger before you disconnect the leads from the battery.
Fuel going to carby but dos'nt seem to be going into carby. Will start for a moment as i pour fuel into chambers?
Hi Kristian, Seems like the needle could be stuck inside the seat.... You need to pull your carby off and unscrew the bottom half from the top, 1st sign of a needle stuck inside the seat is a dry carby There you'll find the float, push the float up and down and see if the needle above the float slides up and down from the seat, If the needle stays up then it's stuck and NOT letting the fuel into the carby, Just pull it down with your fingers to loosen it up. I hope this helps.... CHEERS..
When i got my bike
Which gas line is it? there is one that is a vent and just dangles down and under the bike.
I replaced the fuel tank
The hoses are all different diameters and only fit on the nipples that are the same size. Don't need a diagram for them. they only fit one way.
What does it mean when
There is a loose connection in the wire harness, it could be costly to repair. If it isn't driving you nuts you might just want to live with it. I have seen those types of repairs go upward of $500-$600
BROKEN RINGS
Totally disassemble the WHOLE ENGINE. Rebuild the WHOLE THING. Or go buy another motor and just write off the old motor. They aren't cheap or easy to fix. But they are pretty easy to just change the whole thing.
Shifter hard to go in gear
You didn't drop anything inside of the motor did you? if you did you might have something jammed inside.
Back seat wont open
No. not unless you break it. Shoot some wd40 in there and run the key in and out a few dozen times to loosen everything up. Shoud do the trick.
Not finding what you are looking for?