20 Most Recent
2009 Yamaha yBR125 Questions & Answers
MY YBR ENGINE MANAGEMENT LIGHT FLASHES 3 SHORT FOLLOWED BY 3 FAST
That indicates fault code 33 which is a faulty ignition coil
Fault code 12 - Crankshaft position sensor
Fault code 13 - Intake air pressure sensor
Fault code 14 - Intake air pressure sensor
Fault code 15 - Throttle position sensor
Fault code 16 - TPS
Fault code 19 - No signal from ignition to ecu
Fault code 22 - Intake air temp sensor
Fault code 28 - Engine temp sensor
Fault code 30 - Tip over sensor
Fault code 33 - Igniton coil
Fault code 39 - Fuel injector
Fault code 41 - Tip over sensor
Fault code 44 - Read write error ECU
Fault code 46 - Power supply error to FI system
Fault code 50 - Ecu malfunction
Stator coil problem
its solid and about.5mm but needs to be insulated with shellac or similar resinous material when being re wound
Back brake on my yam ybr 125 2009 keeps sticking
undo the wheel spindle and take it out undo the torque arm bolt undo the adjuster nut on the brake rod ,take the rear brake plate out of the wheel take the brake shoes off, undo the pinch bolt on the brake arm, push the brake arm pivot out and clean and grease it then re assemble it.
When do i change the rear sproket
When your chain is worn the sprockets share the damage. If your chain was razor sharp or wearing unevenly: it's time to change : front sprocket (****** side) rear sprocket and use the proper size chain to match. They sell them in sets. It's quite possible only your chain may need to be changed . Inspect the sprockets! If you haven't done so, purchase a repair book for your bike and carry it with you. The information is found on page.... Good Luck, hope this helps!
How do you change the
Remove fork spring, prise up dust seal, you will then see a clip holding in the main seal, remove this clip, with the spring removed you will then use the fork stancion to remove the seal, holding the fork lower in one hand and the stancion in the other push down on the stancion untill it stops then pull it up sharply, and repeate this hammer action until the fork is sepparated and the seal will then be removed
What will happen if i
yap! its possible........ but i think that's too hi speed... what's your stock sprocket teeth?
Not finding what you are looking for?