indicates that the voltage regulator is not working and the idle drop is from not enough power getting to the electronics because of the head light drain
If the meter is doing its job and counting km's, it means the speedo cable is ok. The problem is most likely inside the speedo...a broken gear or spring perhaps. Try opening the speedo to have a look, if you're good with tools and technically minded.
the size of the ring will be determined by the bore size
so if it is a 3"(75mm) bore the ring will be that size if placed in the bore separate to the piston and pushed square and to the bottom of the bore the ring gap will denote if standard , worn or oversize to standard
new rings in new bores will have a ring gap of around .010"
worn rings will have a larger gap up to .040" and will have sharp edges where the ring lands wear the rings
over size rings in standard bore probably won't even fit in the bore to start with
ring sets are bought in standard size , .010" over size,.020" oversize,.030" oversize,.040" oversize with the oversize equalling the final hone of a machine bore
so if the machine shop bores the cylinder out to .020" oversize then you need .020" oversize rings to maintain the correct ring gap
from experience I have found that if I follow that rule , on measuring the ring gap at the bottom of the bore the ring gap is about .015" or half worn out
I counter this by getting the next size ring .030" and filing the ends of the rings at the gap to obtain the .010" gap This has produced better longer lasting repairs
What are you talking about... valve clearance? Start here.. .0025" - .003" on the intake and .0035" on the exhaustMeasured with the engine COLD and at TDC (compression stroke)
Hi, Anonymous for this situation I would call my local dealer or reputable shop's service/parts department and inquire about any possible quick fix or parts inquiry. If necessary transport your vehicle to the dealer or shop and have a professional technician take it for a test drive, if it is in running condition, and give you a written estimate of repairs and answer any specific questions you may have about your issue. For more information about your issue please visit the website below. Good luck and have a nice day.
did problem happen when you attempted to pull off? if so it could be do do with the safety cut out sensors, i.e the stand the sensor might think the stand is down when it is actually up so the bike will cut out for safety reasons,
bike clutch plates are normally running in special oil as they are wet clutches
for them to burn they will be running dry
read the workshop manual and if you don't have one go google and type in workshop manual for bajaj motor bike boxer model- look for a pdf version to down load
Hello, where are you accessories problems? If you buy a motorcycle, need in motorcycle accessories, you can refer to the below website.http://www.motorpartstore.com.Good luck and have a nice day.