20 Most Recent
2000 Cagiva Planet Questions & Answers
Wont start
Try looking for leaks in the rubber that joins the carb to the cylinder, easiest way to do this is spray a bit of easy start around the rubber area when cranking the engine over. try squirting a bit of easystart into the airbox air intake first to see if it will start with that first, if it does then you need to look at your carb settings as per manual.
Will not idle.
Will not start hot or cold without
By your description, it sounds like the pilot jet is plugged in the carb. Remove carb and clean thoroghly with carb cleaner and air, making sure that all jet passages are clear. Make sure that washer and "o" ring are present on fuel mixture screw, if so equipped. Make sure float level is correct.
Clutch
you need a micrometere or vernier caliper to measure how thick they are that how you tell how worn the clutch is. the manual will list the specificational limit (how thin you should allow them to get and how do the basket and innser hub looks like). if they have small teeth on them they are worn.,
I Have 2013 350 raptor wont start. Replaced ignition coil and ici box and spark plug.. No spark. Still wont turn over
You have written some conflicting information. How can you know that your engine has no spark if it will not turn over? No problem, please write back and elaborate on its issue, symptoms, engine codes and things you have checked and tested so far. At this point I would start looking around. Inspect the battery and power distribution box. Check that the battery connections are clean and tight. Check that the ground cable, going to the body panel is clean and tight. Check all the fuses for damage (over heating or corrosion) and the same for the relays. Is the antitheft system working (does it recognize your ignition key?)? When you turn the ignition hey to the RUN position. Does the gauge cluster respond like it always does? Do you see the lights come on and go out and can you read the odometer mileage? Please write back and let me know. Good Luck.
9/20/2018 3:45:56 AM •
Cagiva...
•
Answered
on Sep 20, 2018
How do you set up timing on a cagiva river 600
Remove the side cover so you can have access to the stator. Then you will be looking for a notch on the inner case. Once you locate the notch you will line up the stator ( which also has a little line or notch on it ) with that notch.
10/20/2016 2:09:26 PM •
Cagiva...
•
Answered
on Oct 20, 2016
CAGIVA CANYON 500 MANUAL
Hello, you need to use manual? If so, the best return to the original car, and you are interested in motorcycle aspects? If you can, you have time to look at.http://www.motorpartstore.com.Good luck and have a nice day
4/9/2016 6:52:01 AM •
Cagiva...
•
Answered
on Apr 09, 2016
Dies when put in gear
Check the kickstand interlock switch. As deemed mandatory by the DOT.. all street legal motorcycles come with a switch in the kickstand pivot area that detects whether or not it is in the upright (or down) position. This is supposed to prevent riders from taking off with the kickstand down, which can ruin your day when the first left hander comes up- This switch will essentially shutdown the electrics to the engine once you attempt to engage first gear (in the down position)...These switches are fairly reliable but can fail. To test it, take a small jumper wire and connect the two wires (going to the switch) together.
1/29/2016 4:43:49 PM •
Cagiva...
•
Answered
on Jan 29, 2016
Not finding what you are looking for?