20 Most Recent 2001 Hartford VR 125H Questions & Answers


Hi, Robblampied for more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.wemoto.com/bikes/hartford_hrd/vr-125_h_x_z/04
https://www.cgmoto.com/motorcycle-parts-HARTFORD.html
HARTFORD CG 125 Service Manual
https://www.ebay.ie/sch/Scooter-Parts/84149/i.html?_sop=19&_nkw=hartford+vr+125
https://www.bikechatforums.com/viewtopic.php?t=254456

2001 Hartford VR... | Answered on Jun 12, 2019


Hi, Debbiegrint and the usual suspects are:
1. Fuel tank empty.
2. The fuel tank has old dead gas.
3. Fuel tank bottom contaminated with ethanol sludge, dirt, water, rust, etc.
4. Fuel supply valve/petcock turned off.
5. Fouled spark plugs.
6. Engine flooded as a result of overuse of the choke.
7. Vacuum hose to the fuel supply valve/petcock disconnected, broken, cracked, or pinched.
8. Fuel valve/petcock or filter clogged.
9. Fuel line to carburetor or throttle body pinched, kinked or blocked.
10. Carburetor float stuck.
11. Fuel injectors clogged.
12. Fuel injectors stuck open.
13. Quick disconnect check ball stuck.
14. Compression below 75 PSI.
15. A stuck-bent-burnt valve.
16. Improper valve clearance (too tight)
17. Severely discharged or a damaged battery should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a cursory reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead-acid batteries.
18. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
19. Loose or corroded wire connection at the coil or plug between ignition sensor and ECM module.
20. Spark plug cables in bad condition and shorting check for spark leakage in the dark, cable connections are loose or connected to the wrong cylinders.
21. Ignition timing incorrect due to a faulty ignition coil, ignition module or MAP, CMP, CKP, O2, TPS, ETP, IAC sensors.
22. Faulty neutral, clutch, kickstand safety switch.
23. Faulty fuel pump or fuse or relay.
24. Faulty or corroded run/stop switch.
25. Tilt sensor needs a reset.
26. Security system not disarming alarm needs a reset.
27. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.denniskirk.com/blog/2014/03/26/steps-take-motorcycle-wont-start
What To Do If Your Motorcycle Doesn Start
HARTFORD CG 125 Service Manual
https://www.cgmoto.com/motorcycle-parts-HARTFORD.html
https://motorcyclespecifications.com/hartford-vr-150z

2001 Hartford VR... | Answered on Jun 12, 2019


hiya

sounds like the switch has gone o/c run a meter over it to see if it has stopped working

hope this helps

John

2001 Hartford VR... | Answered on Oct 26, 2011


Normally 28thou or 0.9mm

2001 Hartford VR... | Answered on Mar 26, 2011


Try internet mc salvage. They have everything.

2001 Hartford VR... | Answered on Oct 13, 2009


Different driving habits load weight and types of trips will make a difference between you and others mpg. Make sure it's tuned properly and you are using the proper gasoline. The gas at the pump is terrible. You could try a gasoline additive to make it run more efficient too. Check that you have the proper tire pressure and that your clutch is adjusted properly And you can always ride slower.,

2001 Hartford VR... | Answered on Nov 10, 2008


Do you know the make and model of the tyre?

Hartford VR 125H... | Answered on May 21, 2013


Hi, you probably have a problem with the clutch or clutch switch. Check to see the defective one and replace to solve the problem....

Hartford VR 125H... | Answered on Apr 20, 2011


Hi, Unstable before testing any electrical component in the Starting Circuit it is "IMPERATIVE" that you have a fully charged battery of 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage, the battery is faulty and must be replaced. AGM type batteries fall into this scenario more so than lead-acid batteries.
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Engine Run Switch is "FAULTY" or corroded.
4. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter.
5. Bank angle sensor needs a reset or is faulty.
6. FOB battery low or dead.
7. Faulty ignition switch.
8. Faulty starter button.
9. Faulty kickstand, clutch, neutral safety switch.
10. Security alarm needs a reset.
11. Starter relay, solenoid, starter motor or circuit wiring faulty.
12. Starter armature or field coils have failed.
13. Main fuse or circuit breaker may be blown or faulty.
14. Faulty ignition relay.
15. The electric starter is working but starter clutch has failed.
16. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://advrider.com/f/threads/hartford-vr-150-question.1054495/
https://www.lifewire.com/fix-non-working-headlights-4137021
https://www.manualslib.com/manual/825652/Hartford-Cg-125.html
https://www.cgmoto.com/motorcycle-parts-HARTFORD-150-VR-150-H-X-Z-2004.html
https://www.motorcycle-manual.com/hartford/

Hartford... | Answered on Oct 28, 2019


why make multiple posts of the same question????
i answered this already its down for reserve and up for main

Hartford... | Answered on Dec 06, 2014


Hi, Anonymous you need to repost your question under the ATV category, not Motorcycles. Thanks, Gregg

Motorcycles | Answered on Jan 16, 2020


Hi, Yunok you need to repost your question under the Electrolux category, not Motorcycles. Thanks, Gregg

Motorcycles | Answered on Jan 16, 2020


Which Moto?
Lesvos-rentals.com

Motorcycles | Answered on Jan 15, 2020


Hi, Steven you need to repost your question under the Polaris Snowmobile category, not Motorcycles. Thanks, Gregg

Motorcycles | Answered on Jan 15, 2020


Hi, Andre you need to repost your question under the Peugeot Car category, not Motorcycles. Thanks, Gregg

Motorcycles | Answered on Jan 15, 2020

Not finding what you are looking for?
2001 Hartford VR 125H Logo

9 questions posted

Ask a Question

Usually answered in minutes!

Top Hartford Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Brad Brown

Level 3 Expert

18157 Answers

Fahr Quad

Level 3 Expert

752 Answers

Are you a Hartford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

VR 125H Hartford

  • VR 125H Hartford

Most Popular Question

size spark

  • Motorcycles
Loading...