Top 20
1982 Honda CBX Questions & Answers
I have a 1982 honda cbx 550 f 2 and have problems
you can try to rebuild it your self there very easy
here are a few thing to try first
Starter Motor Does Not Operate or Does Not Turn Engine Over
1. Engine run switch in OFF position.
2. Ignition switch not in IGNITION position.
3. Discharged battery, loose or corroded connections (solenoid chatters).
4. Starter control circuit, relay, or solenoid faulty.
5. Electric starter shaft pinion gear not engaging or overrunning clutch slipping.
6. Bank Angle Sensor tripped and ignition switch not cycled OFF then back to IGNITION position.
7. Security system activated.
8. Motorcycle in gear and clutch not pulled in.
9. Main fuse not in place.
10. Jiffy stand down and transmission in gear.
How to take seat off
I know metric bikes I have owned there can be a release on left side like a knob.. & hindges up..look for knob.. it should pull out..
I have a 1982 honda cbx,i had to remove the
Try soaking the intake rubbers in hot water, then refit and try again,if the rubbers are too hard soak them in thinners for a few hours or untill their plyability is back to normal and you will have no problem fitting your carbs.
Not firing on #4
hi mate check the coils there are a coil for each plug no 4 cylinder coil could be gone
Honda cbx 6 clutch rattle at idle and low rev hirendouse
Glazed alternator clutch plates? Kind of a ratcheting sound? Common when oil wasn't changed or sitting unused too long.
1. Easy fix - drain oil, remove filter. Add diesel fuel to crankcase. Turn engine over. let sit and drain. Refill with new nonsynthetic oil and replace filter. Warm up. Drain, remove filter. Refill with fresh nonsynthetic oil, and install new filter.
2. Harder, but better. Remove plates and clean or replace them.
I'm looking for a honda
teamrc17.net/file_download/6/Owners_Manual.pdf
go to this site and u will get the users manual of honda cbx
6/4/2011 3:01:19 PM •
Honda CBX...
•
284 views • 1 helpful votes
I have a hole in
I have both a CBX 1000 6 Cyl and a CBX 550 F2 and both tanks are Steel ( My bikes are both UK Spec but I dont think Honda changed the tanks for other countries)
5/6/2011 5:00:29 PM •
Honda CBX...
•
354 views • 0 helpful votes
Fixing an old 1977 honda
I'm thinking that has front brakes. If there is a cable running to hub from handle bars, then yes. Also, look for an arm sticking out from side of center hub that may have had a brake hooked up if no cable from handle bars. Rotating that slightly one way or the other should release brakes, and apply them the other way. If that doesn't work and the linkage (arm) is there for brakes, you may have to pull front wheel and pull it apart to fix.
4/15/2011 10:37:55 PM •
Honda CBX...
•
125 views • 0 helpful votes
How to take out a
loosen the band clamp on both ends of the carb, remove the throttle cables and the fuel lines, if its a cv carb, remove the vacuum lines, then wiggle the carbs out of the rubber boots they are in(airbox and intake boots) . if they are mounted to eachother do not disconnect them. thats all i can give you without knowing which bike you have.
8/22/2010 7:30:33 PM •
Honda CBX...
•
161 views • 0 helpful votes
I am putting a second
Hi,
It's tricky yet easy. Make sure you are following the Service Manuals or the guide you have.
Thanks.
9/4/2009 4:33:00 AM •
Honda CBX...
•
31 views • 1 helpful votes
Honda 500 TRX fa6 has PS on the dash….what does it mean ?
The Power Steering has failed. There has been a factory recall for a suddenly failing electrical steering shaft, that could cause the rider to loose control. This does not have to be your problem but anyhow either the electronics or the pump failed. Error codes or messages usually have to be erased by a simple reset procedure or disconnecting a plug, after repairs are done.
3/17/2024 5:47:57 AM •
Honda...
•
23 views • 1 helpful votes
Not finding what you are looking for?