20 Most Recent 2000 Husaberg Fe 501 E Questions & Answers


depends on what material is stained.. Aluminium stains can be very tricky to get clean if not impossible...some cleaners will also cause a orange/reddish stain wich will not come out unless you use some harsh chemicals to get them out. problem is it's hard to get to those chemicals. IF you happen to have a truck wash nearby where they wash the big trucks (18 wheelers)take your parts there and tell them to use some brightener on it it's a chemical that really cleans aluminium.it may cost you a little bit of money but that stuff really works and i haven't been able to find that stuff for private sale anywhere. the number 2 reasons for stains on the bike are : 1) waiting to long to wash the bike some types of sand/mud especially the red dirt we have down south here will stain a bike if you leave it on the bike not only that it dries as hard as concrete and is very difficult to remove , so was your bike ASAP. 2) washing chemicals. Some chemicals / soaps when they are left too long on aluminium will leave stains as it reacts with the aluminium , these stains are almost impossible to get out. ,,,

2000 Husaberg Fe... | Answered on Nov 10, 2008


Hi, Anonymous and the usual suspects are:
1. Fuel cap or fuel tank is not venting properly.
2. Fuel filter clogged.
3. Fuel line pinched or kinked.
4. Vacuum line from the petcock to intake manifold cracked.
5. Float needle and seat sticking.
6. Float level too low.
7. Carburetor bowl vent line clogged/blocked/pinched.
8. Idle adjusting screw set too low.
9. Air/fuel mixture screw set too lean.
10. Idle port, transfer ports, slow air jet clogged.
11. Slow fuel jet clogged.
12. Faulty fuel pump.
13. Faulty auto choke or wiring connection.
For more information about your issue and valuable "Free" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
http://husaberg.org/fuel/5956-only-runs-choke-any-hints.html
WHY your motorcycle only runs on CHOKE
https://www.repair-manuals.eu/cat/motorcycle_repair_workshop_manuals/repair_manuals_husaberg
http://www.cyclebuy.com/husaberg/parts.htm
https://www.manualslib.com/manual/813892/Husaberg-E-400-E.html#product-FC%20550/4

Husaberg... | Answered on Jun 13, 2019


Hi, Anonymous for this scenario you will need your service manual, parts fiche, and owners manual if you can't find the best tool you ever bought for your Husaberg, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.google.com/search?q=Replace+the+battery+2002+husaberg+470-fxe&source=lnms&tbm=isch&sa=X&ved=0ahUKEwjHooyGkObiAhXqqFkKHcIWB3kQ_AUIESgC&biw=1440&bih=757
http://husaberg.org/electrical/9274-new-owner-fx-470-2002-battery-replacement-question.html
http://husaberg.org/mechanical/11215-workshop-manual.html
http://www.cyclebuy.com/husaberg/parts.htm
https://www.manualslib.com/manual/640214/Husaberg-05.html

Husaberg... | Answered on Jun 13, 2019


The main fuse protects all power consumers of the vehicle. It is located in the starter relay housing under the air filter box lid. (A spare fuse is located in the starter relay)

The fuse box containing the fuses of individual power consumers is located under the seat

Husaberg... | Answered on Feb 26, 2017


Hi, Pete and the usual suspects are:
1. Severely drained or faulty battery.
2. Faulty regulator/rectifier or high output coil.
3. Faulty power valve, solenoid or installation.
4. Clogged air filter or exhaust.
5. Cracked or incorrect float level.
6. Float needle is not seating.
7. Faulty reed valve.
For more information about your question please visit the website below. Good luck and have a nice day.
HUSABERG Pure Enduro Service

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Husaberg... | Answered on Nov 11, 2015


Its a long shot, but try Youtube.
They have tons of DIY videos.

Husaberg... | Answered on Jan 08, 2015


Basically the only way water can get in the oil is if there is a corrosion hole in the housing behind the pump impellor. Water pumps have only 1 seal and if that leaks water will drain from a hole in the pump housing under neath the pump.

Husaberg... | Answered on Mar 11, 2013


Hi, Anonymous you need to repost your question under the ATV category, not Motorcycles. Thanks, Gregg

Motorcycles | Answered on Jan 16, 2020


Hi, Yunok you need to repost your question under the Electrolux category, not Motorcycles. Thanks, Gregg

Motorcycles | Answered on Jan 16, 2020


Which Moto?
Lesvos-rentals.com

Motorcycles | Answered on Jan 15, 2020


Hi, Steven you need to repost your question under the Polaris Snowmobile category, not Motorcycles. Thanks, Gregg

Motorcycles | Answered on Jan 15, 2020


Hi, Andre you need to repost your question under the Peugeot Car category, not Motorcycles. Thanks, Gregg

Motorcycles | Answered on Jan 15, 2020


It takes the alternating current from the Alternator (generator) and turns it into 12 volts DC (direct current - no waveform) to charge your battery.

Motorcycles | Answered on Jan 15, 2020


Hi, Jeremy parts swapping is common with most motorcycles when it comes to interchangeable or compatible parts from one model with another "EXCEPT" for the CDI's they are year-make-model "SPECIFIC" the best thing to do is call your local Dealership Parts Department or a reputable independent shop. If your location is not near a shop then go online and find a parts catalogue or "FICHE" and match part numbers depending on your criteria.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.google.com/search?q=Speedometer+2008+Yamaha+FZ6R&sxsrf=ACYBGNQgTBlkeJIHDHHOB1qpGx2oRyOajg:1579033866795&source=univ&tbm=shop&tbo=u&sa=X&ved=2ahUKEwiVwN_F94PnAhWQwFkKHY2yCT4Qsxh6BAgNECw&biw=1440&bih=757
https://www.jpcycles.com/yamaha-fz6r-dash-and-speedometers
https://www.manualslib.com/manual/761240/Yamaha-Fz6rc.html
https://www.partsfish.com/page/oem-parts-for-yamaha
https://ownersmanuals2.com/yamaha/fz6-shg-2008-owners-manual-55469

Motorcycles | Answered on Jan 14, 2020


The vac line will connect to the inlet tract on the carb

Motorcycles | Answered on Jan 14, 2020


The first thing to check is the battery, read the voltage with a multimeter, a battery in good condition and fully charged should read as 12.6 volts + anything less than 12 volts and the battery is u/s

Motorcycles | Answered on Jan 14, 2020

Not finding what you are looking for?
2000 Husaberg Fe 501 E Logo

2 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Husaberg Experts

Arnie Burke
Arnie Burke

Level 3 Expert

6082 Answers

Marvin
Marvin

Level 3 Expert

85222 Answers

Strech
Strech

Level 3 Expert

1562 Answers

Are you a Husaberg Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Fe 501 E Husaberg

  • Fe 501 E Husaberg

Most Popular Question

husaberg fe 501 e mud stain

  • Motorcycles
Loading...