Top 20
2002 Husaberg Fe 400 E Questions & Answers
Oil check
There are usually two methods to check the oil. One is a dipstick and the other is a sight-glass. You should have one or the other somewhere on the side of the engine crankcase. It should be fairly obvious and not require the removal of any body panels. If you can't find a dipstick in the side of the crankcase you will need to get down on your hands and knees and have a look for a sight-glass instead. This will be like a tiny window with a gauge against which you can check the level.
Where are the fuses on husaberg 450fe 2008 ?
The main fuse protects all power consumers of the vehicle. It is located in the starter relay housing under the air filter box lid. (A spare fuse is located in the starter relay)
The fuse box containing the fuses of individual power consumers is located under the seat
2/26/2017 5:28:30 PM •
Husaberg...
•
145 views • 1 helpful votes
Water pump seals
Basically the only way water can get in the oil is if there is a corrosion hole in the housing behind the pump impellor. Water pumps have only 1 seal and if that leaks water will drain from a hole in the pump housing under neath the pump.
3/11/2013 4:24:47 AM •
Husaberg...
•
426 views • 0 helpful votes
Cleaned my carburetors and the Jets and now my bike won't start. I have a spark but it won't start.
All questions need FULL 'year make model', as the first 3 words.
Then there are 10,000 categories listed by 'make year model'.
So we are working blind.
Make sure gasoline is being delivered to the carbs by removing the fuel delivery pipe.
Carbs come in different systems. If it has a float bowl on the bottom, tap it with the handle of a screwdriver as it may be stuck.
Turn the engine over. If it doesn't start, remove the spark plug and see if it is wet with gas?
You need three things for an engine to start
Clean gas
A spark at the right time
Compression
You have one thing missing
//
2/21/2024 5:36:50 PM •
Motorcycles
•
26 views • 0 helpful votes
Were do the fuel lines go to on a mountop 150cc
This particular unit has a typical GY6-style engine with a fuel line designated from the gas tank to the carburetor distinguished by an in-line cylindrical fuel filter located near the center of the line. Best to locate the carburetor distinguished by the location of the air filter, there should be a hose going from that unit up into the gas tank.
Ideally, remove the gas tank entirely and it should reveal the gasoline lines directly to the carburetor.
The photo shows the fuel line/filter indicated in red, and the location of the carburetor within the blue indicator.
2/27/2024 7:07:40 PM •
Motorcycles
•
23 views • 0 helpful votes
How do I reset 2007 Victory Vegas 8 ball petrol sensor please.
To reset you need to follow this steps below
1.Turn the ignition switch to the "On"position
2.press and hold the trip reset button on the dashboard until the fuel gauge reset or blinks
3.Release the trip reset button
4.Start the engine and let it run for a few minutes to allow the sensor to recalibrate
5.Turn the engine off and then restart it to ensure the reset was successful
2/8/2024 3:04:00 AM •
Motorcycles
•
24 views • 0 helpful votes
Not finding what you are looking for?