20 Most Recent
2005 Husaberg FE 450 e Questions & Answers
Oil filter
i always just put some on the o-ring before i put it back in
but no you dont need to have oil on it,
Hard starting 2010 husaberg 570
1st thing to check is the fuel filter cloth in the bottom of the tank. These bikes came with plenty of crud in the tank that will clog the pick up filter bag in the tank. Once youve checked/fixed that... Check for wire chafing on the frame, its very subtle and difficult to notice. I found mine on the upper section under the rear section of the tank/airbox where it passes through the frame. Mine killed the coolant fan I added. Then I was blowing 10a fuses when I tried to start. After repairing the wiring, add a piece of fuel line or heater hose to prevent a reoccurring issue. Hope this helps
Where are the fuses on husaberg 450fe 2008 ?
The main fuse protects all power consumers of the vehicle. It is located in the starter relay housing under the air filter box lid. (A spare fuse is located in the starter relay)
The fuse box containing the fuses of individual power consumers is located under the seat
2/26/2017 10:43:29 PM •
Husaberg...
•
Answered
on Feb 26, 2017
Water pump seals
Basically the only way water can get in the oil is if there is a corrosion hole in the housing behind the pump impellor. Water pumps have only 1 seal and if that leaks water will drain from a hole in the pump housing under neath the pump.
3/11/2013 4:52:54 AM •
Husaberg...
•
Answered
on Mar 11, 2013
Were do the fuel lines go to on a mountop 150cc
This particular unit has a typical GY6-style engine with a fuel line designated from the gas tank to the carburetor distinguished by an in-line cylindrical fuel filter located near the center of the line. Best to locate the carburetor distinguished by the location of the air filter, there should be a hose going from that unit up into the gas tank.
Ideally, remove the gas tank entirely and it should reveal the gasoline lines directly to the carburetor.
The photo shows the fuel line/filter indicated in red, and the location of the carburetor within the blue indicator.
2/28/2024 4:42:51 PM •
Motorcycles
•
Answered
on Feb 28, 2024
Cleaned my carburetors and the Jets and now my bike won't start. I have a spark but it won't start.
All questions need FULL 'year make model', as the first 3 words.
Then there are 10,000 categories listed by 'make year model'.
So we are working blind.
Make sure gasoline is being delivered to the carbs by removing the fuel delivery pipe.
Carbs come in different systems. If it has a float bowl on the bottom, tap it with the handle of a screwdriver as it may be stuck.
Turn the engine over. If it doesn't start, remove the spark plug and see if it is wet with gas?
You need three things for an engine to start
Clean gas
A spark at the right time
Compression
You have one thing missing
//
2/21/2024 6:59:48 PM •
Motorcycles
•
Answered
on Feb 21, 2024
Not finding what you are looking for?