20 Most Recent
2007 Husaberg FS 550 e Questions & Answers
Maintenance
ProClean is good stuff but not worth the money. The only reason I had it was because I won a create of it at our clubs Supercross race it's too expensive in my opinion.
I buy 40 litre containers of stuff called TFR which stands for Traffic Film Remover, it basically is a detergent like ProClean, Simple Green and all the others, only it costs a fraction of the price and isn't deluted. This means you can delute it to your own strength for different causes. You can see it removing dirt as you watch, like someone said above. You can not use it pure on the bike however, it will make alloy parts go dull - as my buddy found out lol. ,,,
Chain
Every 600 miles or 1000 km. Your motorcycle’s Owner’s Manual will have directions. You need to check the tension at several points along the chain’s travel around the engine and wheel sprockets. The tension should be set so that the loosest spot and the tightest spot are still within the slack tolerance specified in the owner’s manual. If the tightest spot is at the tightest allowed and the loosest is beyond the tolerance then it’s time to get a new chain and sprocket set. ,
T-clocs
tires control lights oil, chassis, stands,,,
Damage check
This would depend on how you drop the bike. If it just falls over you would check everything on that side that could be damaged. It would be the same for a low speed drop. However if the bike not only gets droped but hits something while sliding you might bend the frame or suspension or damage wheels or controls.,,,
Exhust
exhausts are a dark art.......to gain maximum power ..they will need to be of a tuned length...and of certain diameter at certain points....
if your having them made by a reputible(sp) companythey should be abe to get you in the right ball park...
take into consideration groung clearance etc,
Where are the fuses on husaberg 450fe 2008 ?
The main fuse protects all power consumers of the vehicle. It is located in the starter relay housing under the air filter box lid. (A spare fuse is located in the starter relay)
The fuse box containing the fuses of individual power consumers is located under the seat
2/26/2017 10:43:29 PM •
Husaberg...
•
Answered
on Feb 26, 2017
Water pump seals
Basically the only way water can get in the oil is if there is a corrosion hole in the housing behind the pump impellor. Water pumps have only 1 seal and if that leaks water will drain from a hole in the pump housing under neath the pump.
3/11/2013 4:52:54 AM •
Husaberg...
•
Answered
on Mar 11, 2013
Were do the fuel lines go to on a mountop 150cc
This particular unit has a typical GY6-style engine with a fuel line designated from the gas tank to the carburetor distinguished by an in-line cylindrical fuel filter located near the center of the line. Best to locate the carburetor distinguished by the location of the air filter, there should be a hose going from that unit up into the gas tank.
Ideally, remove the gas tank entirely and it should reveal the gasoline lines directly to the carburetor.
The photo shows the fuel line/filter indicated in red, and the location of the carburetor within the blue indicator.
2/28/2024 4:42:51 PM •
Motorcycles
•
Answered
on Feb 28, 2024
Not finding what you are looking for?