20 Most Recent
2002 Husqvarna CR 125 Questions & Answers
How much oil in the gear box of a 2002 cr125 (also % on gas mix
IF you are no riding bike on the trak an not clutching it much i would use a mix ov 40-1[120ml-5L] if on trck an making engine work hard then use 32-1. OIL-if you look to the left of the oil inlet benerth the water pump there is a nut undo it and when the oil stops flowing out then thats what u need in so try and judge it.
Power
it sounds like its not getting enough fuel. make sure the jets are blocked up in the carb.
What is the fork oil level after replacing seals
Here is a manual for your bike....search for English parts of it.....
http://safemanuals.com/user-guide-instructions-owner-manual/HUSQVARNA/CR%20125-_M
The manual has directions for taking out parts, putting in SAE 5 or SAE 7.5 fork oil, and then measuring the distance from the top of the fork tube to the top of the oil. It should be 3.5 inches. That doesn't sound right, but maybe that is with the forks compressed, the directions may be indicating that. You could judge by the amount you drained out of the forks. Here are the directions in the manual.......
OIL FORK LEVEL
For the regular fork operation,
both legs must be provided with
the necessary oil quantity.
Remove the forkrods from the
fork to check the oil level inside
the forkrods. Work as follows:
- remove the power rod caps;
- remove springs from the stems
letting the oil drop into the
latter;
- bring forks to stroke end;
- check that the level is at
distance “A” below the upper
limit of rods.
(distance A is 3.5 inches)
How much fork oil is needed after replacing fork
see manual....but to find out, use measuring cups at least to 13oz's but first release any air pressure before removing drain bolts or it will get real messy. the factory uses locktight on a lot of their bolts...so use long leverage tool..you dont want to strip'em out.
Husqvana 125 mototbike no spark
Need more info has the bike been out in the weather ? If it has unplug the kill switch and ignition switch try and see u get spark if u do clean one switch at s time with wd40 it will take the moster out and clean krosen out of your switches spry and work the switch on and off plug one in and see if u still get spark if u do unplug and try the other one if u dont get spark after u clean then u have a bad switch also check and clean all fuses i hope this helps u remember more info u give the more pple can help with your problem i hope this helps u
Air filter is water wet and will not start
is filter sponge coz water on it will act like a choke is on and over fuel !? if yes then remove it and take sponge off its frame and wash in petrol to clean out water and dirt , squeeze dry and towel dry , then lightly coat filter with oil and replace on bike !
Not finding what you are looking for?