20 Most Recent
2003 Husqvarna SM 125 S - Page 2 Questions & Answers
I have no power to the starter and the battery is good. are there any fuses?
Not on the line to the starter. But the starter switch probably works through a solinoid. If it's not on the starter it's some where between starter and battery . The starter switch must provide the signal to the solinoid. If the Starter switch or ignition switch are not getting "juice" look for bad connections and or a fuse box.
3/16/2015 11:28:52 PM •
Husqvarna...
•
Answered
on Mar 16, 2015
Motorcycle won t start
did you check compression ? when on sand do you clean the airfilter often and oil smear it all over, check crank seals and valves , te510 is that 2 or 4 stroke ? have you checked timing ? and a Good bike mechanic should be able to work on any type of bike with this problem !
1/24/2014 8:35:57 PM •
Husqvarna...
•
Answered
on Jan 24, 2014
Spitting gas out OVERFLOW
carb flooding , clean it and check float needle ok and test the float in a bowl of fuel and make sure it does float !
1/14/2014 5:43:57 PM •
Husqvarna...
•
Answered
on Jan 14, 2014
Spitting gas out overflow from crankcase
What model and year? Because if it is a 4 stroke you have serious problems. If it is a 2 stroke then depending on how much will indicate something of the problem. 2 strokes use the crankcase to pressurise the mixture before feeding it to the combustion chamber. 4 strokes should never have fuel in the crankcase. It would indicate a hole in the piston or failed piston rings.
5/13/2013 9:53:48 PM •
Husqvarna...
•
Answered
on May 13, 2013
Can't keep blower engine going
more than likely your primer bulb diaphram is bad or it could be you have a crack in the gasline that goes into the gas tank or maybe a small crack in the gas tank .... these small cracks wont allow any pressure to build up in the tank to provide the engine with the fuel needed to run. hope that helps
3/9/2013 6:11:34 PM •
Husqvarna...
•
Answered
on Mar 09, 2013
How to adjust clutch on cr50
Nothing will make it easier for him to learn. He will have to learn ... If he can ride a bicycle, he should be able to move right into this small motorcyce. If he CAN NOT ride a bicycle, that is the place to start, not fixing the automatic clutch that isnt broken.
12/19/2012 2:30:38 AM •
Husqvarna...
•
Answered
on Dec 19, 2012
Not finding what you are looking for?